Additional Information
Understanding built-in CD
player error messages
When you contact your dealer or your nearest
Pioneer Service Center, be sure to record the
error message.
Message
Cause
ERROR-11, 12,
Dirty disc
17, 30
ERROR-11, 12,
Scratched disc
17, 30
ERROR-15
The inserted disc
does not contain
any data
ERROR-10, 11,
Electrical or me-
12, 17, 30, A0
chanical
ERROR-22, 23
The CD format
cannot be played
back
ERROR-44
All tracks are
skip tracks
HEAT
CD player over-
heated
CD player and care
! Use only CDs that have either of the two
Compact Disc Digital Audio marks as
shown below.
Action
Clean disc.
Replace disc.
Replace disc.
Turn the ignition
ON and OFF, or
switch to a differ-
ent source, then
back to the CD
player.
Replace disc.
Replace disc.
Turn off the CD
player until the CD
player cools down.
! Use only normal, round CDs. If you insert ir-
regular, non-round, shaped CDs they may
jam in the CD player or not play properly.
! Check all CDs for cracks, scratches or
warping before playing. CDs that have
cracks, scratches or are warped may not
play properly. Do not use such discs.
! Avoid touching the recorded (non-printed)
surface when handling the disc.
! Store discs in their cases when not in use.
! Keep discs out of direct sunlight and do
not expose the discs to high temperatures.
! Do not attach labels, write on or apply che-
micals to the surface of the discs.
! To clean a CD, wipe the disc with a soft
cloth outward from the center.
! If the heater is used in cold weather, moist-
ure may form on components inside the
CD player. Condensation may cause the CD
player to malfunction. If you think that con-
densation is a problem turn off the CD
player for an hour or so to allow it to dry
out and wipe any damp discs with a soft
cloth to remove the moisture.
! Road shocks may interrupt CD playback.
CD-R/CD-RW discs
! When CD-R/CD-RW discs are used, play-
back is possible only for discs which have
been finalized.
Appendix
43
En