Additional Information; Handling Guidelines - Pioneer DEH-X1710UB Manual De Instrucciones

Additional Information

Troubleshooting
The display automatically returns to the
normal display.
 No operations have been made for
about 30 seconds.
– Perform an operation.
The repeat play range changes
unexpectedly.
 Depending on the repeat play range,
the selected range may change when
another folder or track is being selected
or during fast forwarding/reversing.
– Select the repeat play range again.
A subfolder is not played back.
 Subfolders cannot be played when
[FLD] (folder repeat) is selected.
– Select another repeat play range.
The sound is intermittent.
 You are using a device, such as a cellular
phone, that may cause audible
interference.
– Move electrical devices that may be
causing the interference away from
the unit.
Error messages
Common
AMP ERROR
 This unit fails to operate or the speaker
connection is incorrect.
 The protective circuit is activated.
– Check the speaker connection.
– Turn the ignition switch OFF and back
to ON again. If the message remains,
contact your dealer or an authorized
Pioneer Service Station for assistance.
NO XXXX (NO TITLE, for example)
 There is no embedded text information.
– Switch the display or play another
track/file.
CD player
ERROR-07, 11, 12, 17, 30
 The disc is dirty.
– Clean the disc.
 The disc is scratched.
– Replace the disc.
ERROR-07, 10, 11, 12, 15, 17, 30, A0
 There is an electrical or mechanical
error.
– Turn the ignition switch OFF and back
to ON, or switch to a different source,
then back to the CD player.
ERROR-15
 The inserted disc is blank.
– Replace the disc.
ERROR-23
 Unsupported CD format.
– Replace the disc.
FORMAT READ
 Sometimes there is a delay between the
start of playback and when you start to
hear any sound.
– Wait until the message disappears and
you hear sound.
NO AUDIO
 The inserted disc does not contain any
playable files.
– Replace the disc.
SKIPPED
 The inserted disc contains DRM
protected files.
– The protected files are skipped.
PROTECT
 All the files on the inserted disc are
embedded with DRM.
– Replace the disc.
USB device
FORMAT READ
 Sometimes there is a delay between the
start of playback and when you start to
hear any sound.
– Wait until the message disappears and
you hear sound.
NO AUDIO
 There are no songs.
– Transfer the audio files to the USB
device and connect.
 The connected USB device has security
enabled.
– Follow the USB device instructions to
disable the security.
SKIPPED
 The connected USB device contains
DRM protected files.
– The protected files are skipped.
PROTECT
 All the files on the connected USB
device are embedded with DRM.
– Replace the USB device.
N/A USB
 The connected USB device is not
supported by this unit.
– Disconnect your device and replace it
with a compatible USB device.
CHECK USB
 The USB connector or USB cable has
short-circuited.
– Check that the USB connector or USB
cable is not caught in something or
damaged.
 The connected USB device consumes
more than maximum allowable current.
– Disconnect the USB device and do not
use it. Turn the ignition switch OFF
and back to ACC or ON. Connect only
compliant USB devices.
ERROR-19
 Communication failed.
– Perform one of the following
operations, then return to the USB
source.
• Turn the ignition switch OFF and
back to ON.
• Disconnect the USB device.
• Change to a different source.
ERROR-23
 USB device was not formatted properly.
– Format the USB device with FAT12,
FAT16 or FAT32.
STOP
 There are no songs in the current list.
– Select a list that contains songs.

Handling guidelines

Discs and player
• Use only discs that feature either of the
following two logos.
• Use 12-cm discs.
• Use only conventional, fully circular discs.
• The following types of discs cannot be
used with this unit:
– DualDiscs
– 8-cm discs: Attempts to use such discs
with an adaptor may cause the unit to
malfunction.
– Oddly shaped discs
– Discs other than CDs
– Damaged discs, including discs that are
cracked, chipped or warped
En
13