cam Combo S166 Manual De Instrucciones página 15

COMBO 6 DIC 2017 15 lingue_Layout 1 06/12/17 17:33 Pagina 15
they are essential for his safety. Do not lubricate the moving parts of the car
seat. Do not leave the car seat in the car under the sun: the plastic and metal
parts could overheat. Cover the car seat if the car is parked under the sun. Do
not remove the logos of the product to avoid damaging the fabric. Most accidents
happen in town: always use the car seat even for short journeys. Before buying
the product, always check that the car seat can be fitted properly in your car. All
passengers must wear seat belts. Stop often for breaks during long journeys so
that your child is free to move about. Never allow your child to play with the
harness or the buckle on the car seat.
Observe the highway code of your country.
USE IN A VEHICLE
Installation
1. Group 1, for children weighing
between 9 and 18 kg.: forward facing
installation.
2. Groups 2 and 3, for children
weighing between 15 and 36kg:
forward facing installation.
3. Do not fit the car seat on seats
provided with two-point seat belts.
This car seat can only be fitted on seats
provided with a 3-point seat belt
standard approved
UN/ECE Regulation N. 16 or an
equivalent.
4. Methods of installation:
YES – Forward facing
NO – Rearward facing
NO – On seats with two-point seat
belts. Use of the two-point seat belt
increases the risk of injury quite
substantially in the event of an
accident.
YES – On a seat with a three-point seat
belt. The 3-point safety belt must be
standard approved
Regulation UN/ECE N. 16 or equivalent.
(Standard approval is marked by the
symbol showing a letter E in a circle on
the label of the belt).
NO – On front seats
YES – On one of the side back seats
YES – On the middle back seat if it is
fitted with a 3-point seat belt, but not
on the middle back seat if it has a 2-
point seat belt (consisting of the lap
belt only as fitted in some older cars).
NO – On a seat facing sideways.
NO – On a seat facing rearwards.
5. Identify the components of the car
seat before using it. Pay particular
attention to figure 5.
1. Headrest
2. Headrest insert cushion
INSTRUCTIONS FOR USE
3. Backrest cover
4. Harness pad
5. 5-point harness
6. Buckle opening button
7. Buckle pad
8. Spring adjuster
9. Adjusting strap
10. Seat
11. Buckle
12. Backrest insert cushion
13.
mechanism.
14. Headrest strap
according to 15. Slots for adjusting the height of the
5-point harness
16. 5-point harness
17. Passage of car seat belts
18. Metal hook
19. Backrest
20. Headrest cover
21. Seat cover
Check the height of the harness straps.
The straps must be adjusted in the
position
shoulders. If this is not the case, adjust
according to the height of the straps before using
the car seat.
To change the position of the
harness straps:
6. Press the adjuster and at the same
time pull both of the car seat safety
straps. Do not pull the pads wrapped
around the straps.
7. Release one safety strap from the
metal hook located behind the car seat
backrest.
8. Pull out the safety strap from the
backrest.
9. Thread the safety strap into the slot
in the backrest at the required height.
10. Refasten the safety strap to the
metal hook.
Repeat the same procedure with the
other strap.
11. Pull the adjuster strap to tighten
Headrest height
closest to
adjustment
the child's
14