Configuration - Nokia E72 Manual Del Usuario

data connections active at the same time; access points
can share a data connection, and data connections remain
active, for example, during voice calls.
To define the packet data settings, select
connection and When available
the packet data network when you switch the device on
in a supported network, or
device to a packet data network only when an application
or action attempts to establish a packet data connection.
This setting affects all access points for packet data
connections.
To use the device as a packet data modem for your
computer, select Access
name provided by your service provider.
To use a high-speed data connection, select
packet access > Enabled.
WLAN settings
Select Menu Ctrl. panel
>
Wireless LAN.
To have an indicator displayed when there is a wireless
LAN (WLAN) available in your current location, select
WLAN availability > Yes.
To select the interval for your device to scan for available
WLANs, and to update the indicator, select
Packet data
to register the device to
When needed to register the
point, and enter the access point
High speed
Settings and Connection
>
Scan for
networks. This setting is not available unless you select
Show WLAN availability
To set the device to test the internet capability of the
selected WLAN automatically, to ask for permission every
time, or to never perform the connectivity test, select
Internet connectivity test
every time, or
automatically
device asks for it, and the connectivity test is performed
successfully, the access point is saved to internet
destinations.
To check the unique media access control (MAC) address
that identifies your device, enter *#62209526# in the
home screen. The MAC address is displayed.
Advanced WLAN settings
Select Options
WLAN settings are normally defined automatically, and
changing them is not recommended.
>
To edit the settings manually, select

configuration

Long retry limit — Enter the maximum number of
Show
transmission attempts if the device does not receive a
receiving acknowledgement signal from the network.
Short retry limit — Enter the maximum number of
transmission attempts if the device does not receive a
clear-to-send signal from the network.
> Yes.
Run automatically,
>
Never run. If you select
or allow the test to be performed when the
Advanced settings. The advanced
>
Automatic
> Disabledand define the following:
Ask
Run
145