Mitsubishi Electric PAC-YT52CRA Manual Del Usuario página 20

9 Function Selection for CITY MULTI
Make this setting only when the function settings need to be changed on CITY MULTI.
(This setting cannot be made with Mr. SLIM Control System. To make settings for Mr. SLIM,
refer to section
8
Set the functions of each indoor unit from the remote controller, as required.
Refer to the Indoor unit Installation Manual for factory settings, mode No., and the setting No. of the
indoor units.
NOTE: Be sure to write down any settings that you change performing the following steps.
■ Setting the indoor unit Setting Value
ON
1 Press the
OFF
2 Press and hold down the
or longer to check the current settings.
3 When the response has been received from the indoor unit, the current settings appear. If
there is no response, nothing appears.
2 sec.
+
Air conditioner
stops.
4Press the
. .
settings to be made. (ALL, 1 to 50)
5Press the
Function Setting No. to be set. (000 to 255)
6Press the
Function Setting Value. to be set (00 to 15)
ON
7Press the
OFF
Function Selection for Mr. SLIM
button to stop the operation of the air conditioner.
and the
Waiting for response
Response is received.
Response has been received.
and the
. .
button, then press the
button, then press the
button to set the settings.
.)
buttons at the same time for two seconds
No
response
No response
Function Setting Value
Function Setting No.
Indoor unit address
buttons to set the address of the indoor unit whose
. . and the
and the
. .
– 20 –
Procedure A
. . buttons to set the
buttons to set the
. .