Pour In Chain Oil; Bending The Cutting Head; Attaching The Shoulder Strap; Switching On And Off - Grizzly KSHS 710-500 Traducción Del Manual De Instrucciones Original

GB
Observe country-specific and local
regulations. Do not work during
general or mandatory rest periods.
• Before starting, check:
- saw chain tension
- oil level
- that all nuts and screws are securely
in place
• Ensure appropriate protective clothing
is worn.
• Set the working length of the telesco-
pic arm before turning the device on.
• First, briefly remove the protective co-
ver
• Put the shoulder strap on.
• Check you are standing securely.
• Check your working environment.

Pour in chain oil

The blade bar and saw chain must
never be operated without oil.
Non-observance causes increased
wear to the blade and saw chain.
The device is equipped with an automatic
oil system. The oil flows to the blade bar
as soon as the motor starts working.
• Regularly check the oil level using the
viewing window (28) and promptly refill
as necessary.
• Use Grizzly bio-oil containing additives
to reduce friction and wear. You can
order this from our service centre.
• If Grizzly bio-oil is not available, use
chain lubricating oil with a low propor-
tion of adhesion additives.
1. Unscrew the chain oil tank cover (11)
and pour the chain oil into the tank.
2. Wipe away any spilt oil and close the
oil tank cover again.
132

Bending the cutting head

To cut sloping edges on the top of a hed-
ge, you can also pivot the cutting head in
5 positions (-30°, 0°, 30°, 60° and 90°).
Press the locking button (16) and simulta-
neously swivel the hedge trimmer attach-
ment (15). It locks into the desired positi-
on when the locking button is released.

Attaching the shoulder strap

The quick release device (30) re-
leases the device quickly from the
carrying strap. To open the quick
release device (30), press the two
clamps together.
Put the shoulder strap on.
Attach the snap hook of the shoulder
strap ( 29)) to the fastening eye (
on the tubular shaft of the device. Adjust
the strap length so that the snap hook of
the shoulder strap is level with the hip.
You can vary the strap length using the
buckle on the shoulder strap.
When wearing the shoulder strap,
ensure that the pad is placed on
your shoulders to increase comfort.

Switching on and off

1. Connect the device to the mains volta-
ge supply.
2. Hold the device firmly with both hands,
with your right hand on the operating
handle and left hand on the soft grip.
Your thumb and fingers must tightly
clasp the handles.
3. To turn on, press the switch lock (2)
and then press the on/off switch (3);
the device will run at top speed. Re-
lease the switch lock (2).
4)