Cleaning; Maintenance; Sharpening The Cutting Teeth; Changing The Saw Chain - Grizzly KSHS 710-500 Traducción Del Manual De Instrucciones Original

GB
You should have any repair and
maintenance work that is not
described in these instructions
(e.g. replacing carbon brushes)
carried out by a specialist com-
pany. Only use original Grizzly
spare parts. Allow the device to
cool off before undertaking any
maintenance or cleaning work.
There is a danger of burns!
Always remove the mains plug be-
fore working on the device.
Wear gloves when handling the
blades.

Cleaning

Do not use any solvents or petrol
for cleaning. This could damage
the device.
• Clean the surface, ventilation slits and
handles on the device using a dry clo-
th, paintbrush or hand brush.
• Only dry wipe the saw chain. After cle-
aning, apply a small amount of chain
oil to the saw chain.
Apply individual drops of oil on the
joints and on the tooth tips of the indi-
vidual chain links.

Maintenance

• Check the hedge trimmer before each
use for obvious defects such as loose,
worn or damaged parts. Ensure that
the screws in the cutter bar are firmly
in place.
• Do not cut with blunt or worn blades
as otherwise you will overload the mo-
tor and gears of your device.
136
• Check the covers and protective
devices for damage and correct fit.
Replace these if necessary.
• Keep the ventilation slits and the mo-
tor housing of the device clean. Use
a damp cloth or brush to do this. The
device must neither be sprayed with
water nor be put into water.
• Do not use any cleaning agents or sol-
vents. This could damage the device
irreparably. Chemical substances may
attack the plastic parts of the device.
• Always keep the device clean. After
each use of the device, you must
- clean the blade
(with an oily cloth)
- oil the cutter bar
with an oil can/
spray.
• The gears are main-
tenance free.

Sharpening the cutting teeth

Have the saw chain sharpened by a spe-
cialist, or proceed in accordance with the
operating manual for your saw chain shar-
pening device. Sharpening a saw chain
requires some practice. Replacing the
saw chain is preferable in case of doubt.

Changing the saw chain

Never attach a new saw chain onto
worn teeth, or onto a damaged or
worn blade bar.
1. Switch off the device and unplug the
mains plug.
2. Loosen the blade mounting screw
( 13) and remove the sprocket co-
ver ( 12).
3. Remove the old saw chain ( 19).