Tabla de contenido
Publicidad
USB MAGNETIC CHARGING CABLE -- MCC3
Parameter
Speci cation
USB type A - magnetic charging connector, length: 0.5m
Charging cable
Input
USB A - Type DC 5V 2A
CC&CV
Charging pattern
Maximum
2A
charging current
Voltage of fully
4.2V±0.05V
charged battery
Red：charging
Charge indication
Green: full (over 95%) or disconnected with flashlight
5 hours (For reference only. When the USB power source
Time to fully
is insufficient to provide 5V 2A power capacity, the
charge
charging time will be longer)
CHARGING
GREEN
Charging Completed
RED
Charging
* Before first use please fully charge the product.
* Connect the USB end of the magnetic charging cable to an
external USB power source, then attach the other end of the
cable to the charging port of the light (best charging
efficiency with a 10W (5V 2A) USB power source). The red
indicator means charging, while the green indicator means
charging completed (battery level＞95%).
* Only charge with standard MCC3, not compatible with other
MCC.
DANGER
•DO NOT shine the light directly into human eyes. This may cause
temporary blindness, or permanent damage to the eyes.
•When the flashlight is turned momentarily on with the high white
light, the proximity sensor will not work. On this account, please
DO NOT shine the light towards any object within 20cm for a
prolonged period to avoid hazards.
•DO NOT cover the flashlight's head or stand the flashlight on its
head when it is on. The radiation energy may cause damage to
the flashlight itself, or even result in the burning of flammable
objects nearby.
WARNING
•The tail switch may not work while immersed in sea water or
other conductive media. Please try to keep it clean and dry.
•DO NOT use Non-protected rechargeable batteries.
•Please lock out the switches if the flashlight is left unused,
carried, or transported. The heat built-up due to accidental
activation may melt the lens of the flashlight, cause close
objects to burn, or even result in unexpected disasters.
NOTICE
•DO NOT short-circuit the tail switch cap with the ring
surrounding it. The short circuit in this case will result in an
electric discharge of below 3mA between them, and may lead
to a complete battery drain if it is in this state for too long.
•The built-in proximity sensor is underneath the front lens. When
the high white light is on, the sensor will dim the brightness
automatically if it senses a close-up obstruction or a strong
light source right ahead, like sunlight, bright street lamps, car
headlights, etc. The brightness will restore when the
obstruction is gone and the light source is not right ahead.
•The maximum output brightness will decrease as the battery
voltage decreases.
•The proximity sensor will stop working when the battery is low
and the brightness of the high white light has decreased to a
safe level.
•The response distance of the proximity sensor may vary from
3cm to 50cm according to the reflectivity of obstructive objects.
The higher the reflectivity, the farther the distance.
•The sensor may NOT work if it is blocked by water, dirt, or
scratches on the front lens. Please keep the lens clean to
ensure that it works properly.
•The white light should only be set at low mode or moonlight
mode when used with the silicone traffic wand.
CONTENTS
01
01
02
03
03
04
05
05
06
07
08
09
10
11
12
12
13
14
15
Publicidad
Tabla de contenido
