Print Fail Error Handling - Hiti X610 Manual De Instrucciones

Print Fail Error Handling

In case of loose ribbon, scroll the ribbon as tight as possible. If there is a tear in the ribbon, tape it back
together, then scroll till the broken part of the ribbon cannot be seen. If issue still occurs, please contact
local technical support.
In case of other errors such as CAM error or Cutter error, do not open paper door or ribbon door. Please restart
the printer first, if printer does not show "Printer Ready" and error still occurs, please contact local technical
support.
Turn off printer, take out
ribbon
When print fail or paper jam occurs, please turn off the printer first. Then open and pull out ribbon door,
open paper door, then roll out jammed paper. If issue still occurs, please contact local technical support.
Step1. Turn off printer,
open and pull out ribbon
door. Make sure to
separate ribbon cartridge
from the printer, if ribbon
is jammed into the printer,
please cut it loose. *
*There might be some resistance.
Place ribbon on flat surface
Step2. Open paper door.*
8
HiTi X610 User Manual
Tape the ribbon back together ,
and place ribbon back onto
cartridge. Make sure to scroll the
ribbon back onto the cartridge as
tight as possible, till the broken
part of the ribbon cannot be seen.
Step3. Hold onto the
flange and roll it as the
arrow indicated to roll
out jammed paper.*
English
Step4. Roll out paper
until paper jammed
part is visible. Use a
scissor to cut off paper
jam part.