Operation; Switching On And Off; Inserting/Replacing The Blade; General Working Instructions - Grizzly Tools AGS 108-2 Lion Traducción Del Manual De Instrucciones Original

GB
The charging indicator (6a)
lights up:
Red: Equipment charging.
Green: Charging finished.
The recommended charging
time is max. 3 – 5 hours.
For your protection, the device
cannot be switched on while it
is being charged up. The on/off
switch is locked.
4. After the recharging process
is completed, first unplug the
charger from the wall outlet, and
then remove the charger cable
plug from the tool.

Operation

Keep to noise abatement regula-
tions and other by-laws.

Switching on and off

1. Remove the blade guard (12/15) be-
fore switching the unit on.
2. To switch on, hold the switch lock
(2) depressed and operate the on/off
switch (8). Then release the switch
lock.
The equipment runs at top speed.
3. In order to switch off, let go of the on/
off switch (8).
After switching the unit off, the
blades take a short time to stop
moving. Let the blades come
to a complete standstill. Do not
touch the moving blades and
do not try to stop them moving.
Injury hazard!
80
Inserting/replacing the
blade
Prior to each exchange of the
blades, make sure the device is
switched off and the battery
( 7) removed in order to pre-
vent hazards and injuries!
Remove blade
1. Press the unlock buttons (11/14) on
the blade and remove the entire blade.
Insert blade
2. Insert the grass shear blade (10) or
the shrub shear blade (13) into the re-
cess in the cutter head (1).
3. Press the blade into the direction of
the cutter head (1). It locks into place
audibly.

General working instructions

While trimming, take care that
there are no objects such as wire,
metal parts, stones etc. come into
contact with the blades. This can
lead to cutting head damage. If the
blades become blocked by solid
objects, switch off the unit at once.
• Check the grass and bush trimmer
blades for obvious defects such as
loose, worn or damaged parts. Check
that the screws are seated firmly in the
blade block.
• Remove the power supply unit before
working with the equipment. Do not
use extension cables. The power sup-
ply unit is to be used only in enclosed
spaces.
• Only use sharp blades to achieve a
good cutting performance and pre-
serve the battery.