Use As A Grass Trimmer; Use As A Hedge Trimmer; Cleaning/Maintenance; Cleaning & Maintenance - Grizzly Tools AGS 108-2 Lion Traducción Del Manual De Instrucciones Original

• Do not work the unit so hard that it
comes to a standstill.
• Pay attention to the instructions on
unit maintenance and cleaning.

Use as a grass trimmer

• Grass is best cut when dry and not too
long.
Adjusting the working angle
For a comfortable edge cut, the cutter
head (1) can be rotated by 90° to the right
or left.
1. Operate the lever (3) and turn
the cutter head (1) into the de-
sired position.
2. Release the lever (3), the cutter
head locks into place.
In addition, the device has 3 inclination
positions for the handle setting
1. Operate the release button (9)
and tilt the handle (1) into the
desired position.
2. Let go of the release button (9)
so that the handle locks into
place.

Use as a hedge trimmer

Do not use the shrub cutter in
combination with the telescopic
shaft. There is a risk of cut
wounds.
• Move the unit forward evenly.
• The double-sided cutting heads en-
able cutting in both directions or by
swinging the unit from side to side.

Cleaning/Maintenance

Leave any work not covered
in this manual to our Service
Centre. Only use original parts.
There is a risk of injury!
Ensure that the battery (
moved before carrying out any work.
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on
the unit.
Wear gloves when handling the
blades (
of injury from cuts!
Clean and service the unit regularly as fol-
lows. This guarantees a long life for your
unit:
• Check the covers and guards for dam-
age and correct position. If necessary,
replace.
• Keep the ventilation slits, motor hous-
ing and handles on the equipment
clean. To do this, use a damp cloth or
brush.
• Always keep the blade clean.
After using the equipment, it is impera-
tive to:
- Clean the blade
(with an oily cloth);
- Oil the blade shaft
with an oil can or
spray.
• Slight notches on the blades can be
evened out. For this, sand down the
blades with an oil stone. Only sharp
blades can cut properly.
• Blunt, bent or damaged blades must
be changed.
GB
7) is re-
10/13). There is a risk
81