Worx WG118E Manual Original página 10

symbols
Read operator's manual
Double insulation
Wear ear protection
Wear eye protection
Keep bystanders away
Switch off! Remove plug from
mains before adjusting, cleaning or
if cable is entangled or damaged.
10
Do not expose to moisture.
This product has been marked
with a symbol relating to removing
electric and electronic waste. This
means that this product shall not
be discarded with household waste
but that it shall be returned to a
collection system which conforms
to the european Directive 2002/96/
Ce. It will then be recycled or
dismantled in order to reduce the
impact on the environment. electric
and electronic equipment can be
hazardous for the environment
and for human health since they
contain hazardous substances.
2-in-1 Grass Trimmer/Edger
edging
Trimming
assEmbly
1. ASSEMBLy OF THE SAFETy GuARD
(See Fig. A)
Remove the screw from the Safety Guard (3)
and fit the guard to the trimmer head; align
the guard so it slides into the slots located
on the trimmer head. Turn the tool over and
secure the Safety Guard onto the trimmer
head with the screw (a) provided.
2. ASSEMBLy OF THE EDGER WHEEL
(See Fig. B)
With the tool right side up, slide the edger
Wheel (7) assembly onto the metal plate
located on the side of the trimmer head.
Make sure the grooves of the edger Wheel
assembly lock onto the metal plate; you will
hear it click into place.
To remove the wheel assembly, press the
release button (b) on the wheel and pull the
wheel assembly upward.
oPEraTinG insTrUcTions
INTENDED uSE
The machine is intended for the cutting of
grass and weeds under bushes, as well as
on slopes and edges that can not be reached
with the lawn mower.
WARNING: THE CuTTING HEAD
CONTINuES TO ROTATE AFTER THE
TRIMMER HAS BEEN SWITCHED OFF.
WAIT uNTIL IT STOPS BEFORE LAyING
THE TRIMMER DOWN.
• Always wear eye protection. Never lean
over the trimmer head. Rocks or debris can
ricochet or be thrown into the eyes and
face and cause blindness or other serious
injury.
• Hold front handle with one hand and
auxiliary handle with the other hand. Keep
unit below waist level. Work only from
your right to your left to ensure debris is
thrown away from you. Without bending
over, keep line near and parallel to the
ground (perpendicular when edging) and
not crowded into material being cut.
• Before operating, make sure both trimmer
lines are extended. When trimming, make
En