Environmental Protection - Worx WG118E Manual Original

11. MANuALLy FEEDING THE LINE (See
Fig. J)
Press and release the Line feed Button (15)
(See fig. J) whilst gently pulling out on one of
the lines until it has reached the line cutter.
When the required amount of line is fed out,
gently pull on the second line (there is no
need to press the Line feed Button again). If
the line extends past the line cutter, too much
line has been fed out.
If too much line is fed out, remove the spool
cap and click the spool counter-clockwise until
the line is at the desired length.
12. REMOVING THE CAP
Press and hold in the two Cap Release
Latches (11) (See fig K).
Pull the Cutting Head Cover (10) away from
the Cutting Head (13). Keep the Cutting Head
Cover and the inside of the Cutting Head
clean from debris. To replace the Cutting
Head Cover, press it firmly onto the spool
holder. ensure that it is correctly connected
by trying to remove it without depressing the
two Cap Release Latches.
13. CHANGING THE LINE SPOOL
12
first take off the Cutting Head Cover (10) and
remove the old Spool (12). Place the new
Spool onto the Cutting Head (13). feed one
line through the eyelet (14), and then repeat
for the second line. Reattach the Cutting
Head Cover.
WARNING! Your Trimmer is designed
to only use line with a maximum
diameter of 0.065 (1.65mm" . only use nylon
line.
IMPORTANT - Always wind the line onto the
upper section of the spool first.
14. TO MANuALLy WIND LINE
Take approximately 5m of line and insert
15mm of line into one of the holes in the
upper section of the Spool (12) (See fig L1).
Wind the line in the direction of the arrows
on the top of the Spool. Repeat process with
separate piece of line on lower section of
Spool (See fig. L2 & L3).
Leave approximately 100mm of line unwound
and place it into the cleat. Repeat on the
lower section of the Spool.
Care should be taken to ensure that the line
is neatly coiled on the Spool (See fig L4).
2-in-1 Grass Trimmer/Edger
failure to do so will impair the efficiency of
the automatic line feed.
Then fit the Spool as described above in
"Changing the Line Spool".
mainTEnancE
After use, disconnect the machine from the
electrical outlet and check for damage. Your
trimmer requires no additional lubrication or
maintenance. There are no user serviceable
parts in your trimmer. electric powered
trimmers should only be repaired by an
authorized repairer. Use only manufacturers
recommended replacement parts and
accessories.
Never use water or chemical cleaners to clean
your trimmer. Wipe clean with a dry cloth.
Always store your trimmer in a dry place
out of the reach of children. Keep the motor
ventilation slots clean. If you see some sparks
flashing in the ventilation slots, this is normal
and will not damage your trimmer.
EnVironmEnTal
ProTEcTion
This product has been marked with a
symbol relating to removing electric
and electronic waste. This means that
this product shall not be discarded
with household waste but that it shall be
returned to a collection system which
conforms to the european Directive 2002/96/
Ce. It will then be recycled or dismantled in
order to reduce the impact on the
environment. electric and electronic
equipment can be hazardous for the
environment and for human health since they
contain hazardous substances.
En