Uline H-2895 Instrucciones De Montaje página 2

1
6
7
NOTE: Hold the data cable (6) out of the way
as you push up on the motor assembly/bottle
support. Continue pushing upward until the
vertical slots in the dispenser shank and the
motor assembly/bottle support line up.
1
7
NOTE: The clip may be inserted from either side.
11
6
8
anchors included (if attaching to a plaster or
masonry surface). Use the wall clip (11) to secure
the power cable (6) to a wall or other under-counter
8
PAGE 2 OF 9
INSTRUCTIONS CONTINUED
5. 4. Align the indent
inside the tip of the motor
assembly/bottle support (7)
with the indent on the shank
of the dispenser assembly
(1) and firmly push the motor
assembly/bottle support up,
onto the shank.
6. 5. Secure the motor
assembly/bottle support (7)
to the dispenser assembly
(1) shank by pushing the
retaining clip (5) into place
through the vertical slots, until
it goes all the way through
5
the motor assembly.
7. 6. Remove the cover
from the battery box (8) by
loosening the two captive
screws on the battery box
cover. Position the box on
a convenient (vertical or
horizontal) surface under the
counter top that will allow
access for battery changing.
Attach the box to the surface
using the two screws and
surface if desired.
8. 7. Insert four "D"
batteries into the battery
box (8). If the batteries are
not properly installed or
the cover is not properly
positioned on the box, the
system will not work. Position
the cover (with batteries
installed) on the battery box
and tighten the two captive
5
5
NOTE: After the batteries are installed in the
battery box and the two halves of the data
cable are connected, it will take approximately
20 seconds before the Touchfree Counter
A
Indents
9
Slide the bottle upward until it snaps into place.
1
Actuation
zone
several times, repeat several more times. If no sound
is heard from motor assembly after placing hands
in front of sensor, check to see that the data cable
halves are firmly connected, that the batteries are
"good", and that the battery box cover is properly
screws.
9. 8. Connect the two
halves of the data cable (5)
by visually lining up the white
stripes on each half and
gently pushing the cable
connectors together until
the stripes touch. Improperly
assembled connectors can
cause unit to not function as
intended.
Mounted System is ready
to dispense soap.
REFILL INSTALLATION (RE-
FILL SOLD SEPARATELY)
10. 9. Feed the dispense
tube (A) on the refill bottle
(9) up through the motor
assembly/bottle support (7)
and dispenser assembly,
aligning the two indents in
the bottle and the support.
NOTE: The refill is not
properly installed until you
hear the "snap" (as the
green release latch on
the motor assembly/bottle
support (7) engages).
11. 10. Test the system by
passing your hand under
the spout of the dispenser
assembly (1) (in front of the
sensor window) at least
three or four times, until
foam soap appears. If the
system does not dispense
soap after passing your
hand in front of the sensor
0421 IH-2895