Technical Data - Black and Decker FSMH1300FX Traducido De Las Instrucciones Originales

Allow the unit and all accessories to cool before attempting to
remove.
Removing an accessory
Twist the accessory clockwise then pull away from the
u
hose (12).
Removing the hose
Press the steam hose release button (17) on the steam
u
hose (12) and pull away from the hand held steam unit.
Hints for optimum use
General
Caution: Never use the steam mop without first attaching a
cleaning pad.
Always vacuum or sweep the floor before using the steam
u
mop.
The easiest way to use the appliance is to tilt the unit to
u
a 45º angle and clean slowly, covering a small area at a
time.
Use water only with no additives or chemicals with your
u
steam mop. To remove stubborn stains from vinyl or
linoleum floors, you can pre-treat with a mild detergent
and some water before using the steam mop.
Steam Cleaning with the mop
Fit hand steam cleaner to the floor extension (8)
u
Place a cleaning pad (10) on the floor with the velcro 'loop'
u
side facing up.
Lightly press the steam mop down onto the cleaning pad
u
(10).
Connect the steam mop to the mains.
u
Press the ON/OFF button (1). It takes approximately 20
u
seconds for the steam mop to heat up.
Turn the Autoselect dial (2) until the required setting is
TM
u
reached. After a few seconds steam will start to come out
of the steam head.
Note! When first filled or after running dry, it can take up to 45
seconds for steam to be produced.
It takes a few seconds for steam to enter the cleaning pad.
u
The steam mop will now glide easily over the surface to be
sanitized/cleaned.
Push and pull the steam mop slowly across the surface to
u
thoroughly steam clean each section.
When you have finished using the steam mop, return
u
the handle (8) to the upright position, making sure that it
is supported and turn it 'OFF'. Wait until the steam mop
cools down (approximately five minutes).
Caution! It is important to monitor the water level in the water
tank. To refill the water tank and continue to sanitize/clean
stand the mop upright making sure that it is supported and
turn the steam mop 'OFF'.
(Original instructions)
Unplug the unit from the electrical wall outlet, and refill the
water tank.
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
supported in the upright position when stationary and make
sure the steam mop is turned off when not in use.
After use
Turn the Autoselect dial (2) to the OFF position.
TM
u
Wait until the steam mop cools down.
u
Unplug the steam mop from the electrical wall outlet.
u
Empty the water tank.
u
Remove the cleaning pad (10) and wash it ready for next
u
use (take care to follow the wash care instructions printed
on the cleaning pad).
Accessories
The performance of your appliance depends on the accessory
used. BLACK+DECKER accessories are engineered to high
quality standards and designed to enhance the performance
of your appliance. By using these accessories you will get the
very best from your equipment.
Hand held steam cleaning
Warning! Maintain the unit in a horizontal position during
use.
Attach the required accessory.
u
Connect the hand held steam cleaner to the mains.
u
Press the ON/OFF button (1). It takes approximately 20
u
seconds for the steam mop to heat up.
Turn the Autoselect dial (2) until the required setting is
TM
u
reached. After a few seconds steam will start to come out
of the steam head.
Note! When first filled or after running dry, it can take up to 45
seconds for steam to be produced.
When you have finished using the hand held steam
u
cleaner turn the Autoselect
Turn the unit OFF by pressing the ON/OFF button (1) and
disconnect from the mains supply. Wait until the unit cools
down before storing (approximately five minutes).

Technical Data

Voltage V
ac
Power W
Tank Capacity ml
Weight
kg
Troubleshooting
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
ENGLISH
dial (2) to the OFF position.
TM
FSMH1300FX Type 3
230
1600
500
2.4
11