Bluetooth Connection And Settings - Toyota MyT 4G box Guia De Inicio Rapido

Note:
By disabling the Wi-Fi connectivity you will immediately lose the connection between your
device and the MyT 4G box. Once disabled, the Wi-Fi of your MyT 4G box can be enabled only
by pressing the Wi-Fi On/Off button.
You can change the basic settings of your MyT 4G box Wi-Fi network as:

Network name (SSID): Enter a string of maximum 32 characters as the name for your
wireless local area network (Wi-Fi). Upper case, lower case, numbers, standard and
enhanced punctuation are allowed.

Security mode: There are four security modes for you to select: OPEN, WEP, WPA2
(AES)-PSK and WPA-PSK/WPA2-PSK. For OPEN mode, there is no need to set
password. For WEP, WPA2 (AES)-PSK and WPA-PSK/WPA2-PSK mode, you need to
set password for the security.

Password: Change the password related to the selected security mode. 8, 32 or 63
characters (upper case, lower case, and numbers) can be used for WPA2 (AES)-PSK and
WPA-PSK/WPA2-PSK while 5 or 13 characters (upper case, lower case and numbers)
can be used for WEP.

Maximum Station Number: Set the maximum numbers of other devices connecting to
your MyT 4G box.

Bluetooth connection and settings

Note:
Radly Internet radio service via Bluetooth is not available on all Toyota models. Please refer to
the compatibility list available in the Frequently Asked Questions section of MyToyota website
(http://my.toyota.eu).
Bluetooth connection with the car audio system might have been already completed during the
installation of the product in the car. In this case, you can directly select the MyT 4G box in the
paired Bluetooth devices list in the audio system menu.
By selecting the MyT 4G box as Bluetooth audio source you will enjoy Radly Internet Radio.
The Bluetooth name of your MyT 4G box is reported on the label present on the front side of the
device (next to the reset button) and on the front page of the owner's manual.
If your MyT 4G box Bluetooth is not yet paired with your in-car multimedia system, refer to the
multimedia system owner's manual to complete the pairing.
Note:
The pairing must be started within 2 minutes after the vehicle ACC power is turned ON,
otherwise the Bluetooth of your MyT 4G box will not be visible.
To make it visible again after 2 minutes, restart the MyT 4G box by restarting the vehicle, or go
to the Bluetooth menu of the MyT 4G box, and select "Enable" in the section "The device can
be detected by all Bluetooth devices nearby".
Note:
In certain car models the Bluetooth pairing process must be started from the MyT 4G box:
1. Set your in-car multimedia system to "Discoverable mode" or "Pairing mode". Please refer
to your in-car multimedia system owner's manual to see how to activate this mode.
MyT - 12