Krups Espresso Novo 2300 Plus Manual De Instrucciones página 20

We recommend that you clean the
autocappuccino accessory immediately after
use - please refer to paragraph «Cleaning the
autocappuccino accessory».
. Preparing frothy milk for a cappuccino:
Fill the water tank (1) (2) (3) and start the
•
appliance (5).
Move the nozzle to the exterior of the
•
appliance and mount the autocappuccino
accessory on the nozzle (18).
Turn the selector to the
•
Immerse the flexible tube in the milk to be
•
heated. The tube must touch the bottom of
the container (20).
Place a cup one third filled with freshly-
•
made espresso (20) under the outlet nozzle.
Place the tap in the
•
will obtain a fine smooth froth.
To obtain milk which is less frothy, turn the
•
tap to the top of the user scale.
Once the appliance reaches the right
temperature, the orange temperature control
light will go out.
Turn the selector to the
•
Hot frothy milk will come out of the outlet
nozzle.
Once you have obtained the desired
•
quantity of frothy milk, turn the selector to
the O setting.
After use, remove the flexible tube from the
•
container and clean the autocappuccino
accessory (see «Maintenance»).
. Preparing hot, lightly whipped milk for
café crème, hot chocolate or for heating
water (for tea, for example).
Notes:
Café crème: place the cup containing the
.
freshly-prepared coffee directly under the
outlet nozzle.
Hot chocolate: immerse the flexible tube
.
directly into the carton if the chcoclate is
ready-made,
or heat the milk if you are using powdered
chocolate. Then mix the powder in the heated
milk.
20
setting (19) .
setting (21). You
setting (22) .
Move the nozzle to the exterior of the
•
appliance and mount the autocappuccino
accessory on the nozzle (18).
Fill the water tank (1) (2) (3) and start the
•
appliance (5).
Turn the selector to the
•
• Turn the tap of the autocappuccino
accessory to the fine end of the setting
scale (23).
Immerse the flexible tube in the liquid to be
•
heated. The tube must touch the bottom of
the container (20).
Place a container under the outlet nozzle
•
(20).
Once the appliance reaches the right
temperature, the orange temperature control
light will go out.
Turn the selector to the steam setting
•
(22).
Once you have obtained the desired
•
quantity of frothy milk, turn the selector to
the O setting.
• After use, remove the flexible tube from the
container.
. Heating thick liquids (soup, for example)
Move the steam nozzle to the exterior of the
•
appliance and mount the autocappuccino
accessory on the steam nozzle (18).
Fill the water tank (1) (2) (3) and start the
•
appliance (5).
Turn the selector to the
•
Turn the tap on the autocappuccino
•
accessory to the
Immerse the flexible tube in the liquid to be
•
heated (25).
Once the appliance reaches the correct
temperature, the orange temperature control
light will go out.
Turn the selector to the
•
the liquid is hot enough, then reset the
selector to the O setting and remove the
container.
setting (19) .
setting (19).
setting (24).
setting (22) until