Storing The Trimmer; Environmental Protection - GGP ITALY MT48Li Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
7
EN
■ Remove the spool from the cutting head.
NOTE: Remove any old cutting line remaining on the
spool.
■ Cutting a piece of cutting line approximately 3m
long.
■ Insert the cutting line into the anchor hole in the
upper part of the spool. Wind the cutting line
around the upper part of the spool clockwise, as
shown by the arrows on the spool. Place cutting
line in theslot on upper spool flange, leaving about
15cm. Extended beyond the slot. Do not overfil.
After winding the cutting line, there should be at
least0.635cm between the wound cutting line and
the outside edger of the spool.
■ Replace the spool, and the spool cover. Refer to
spool replacement earlier in this manual.

STORING THE TRIMMER

■ Remove the battery pack from the trimmer before
storing.
■ Clean all foreign material from the trimmer.
■ Store it in a place that is inaccessible to children.
■ Keep away from corrosive agents such as garden
chemicals and de-icing salts.
■ Store and charge your batteries in a cool area.
Temperatures above or below normal room
temperature will shorten battery pack life.
■ Never store batteries in a discharged condition.
Wait for battery pack to cool and fully charge
immediately.
■ Store the battery pack where the temperature is
below 27˚C and away from moisture.
■ All batteries gradually lose their charge. The higher
the temperature, the quicker they lose their charge.
If you store your unit for long periods of time without
using it, recharge the batteries every month or two.
This practice will prolong battery pack life.

ENVIRONMENTAL PROTECTION

■ Environmental protection should be a priority of
considerable importance when using the machine,
for the benefit of
the environment in which we live. Try not to cause
any disturbance to the surrounding
■ Scrupulously comply with local regulations for the
disposal of packaging, deteriorated parts or any
elements with a
this waste must not be disposed of as normal waste,
it must be separated and taken to
waste disposal centres where the material will be
recycled.
■ Scrupulously comply with local regulations for the
disposal of waste materials after mowing.
■ At the time of decommissioning, do not pollute the
environment with the machine, but hand it over to a
disposal centre, in accordance with the local laws
in force.
DISPOSAL
Do not dispose of electrical equipment with household
waste material. In observance of European Directive
2012/19/EC on waste electrical and electronic
equipment and its implementation in accordance
with national regulations, electric equipment that
has reached the end of its life must be collected
separately and recycled in an ecologically compatible
way. If electrical equipment is disposed of in dumps
or in landfills, hazardous substances can leak into the
groundwater and get into the food chain, damaging
your health and well-being. For further information on
the disposal of this product, contact a domestic waste
collection authority or your dealer.
OPERATION
both social coexistence and
area.
strong environmental impact;
specified

Publicidad

Tabla de contenido
loading

Tabla de contenido