Uline H-8224 Instrucciones De Montaje página 2

A
Floor Glide x 8
E
Open H-6859 carton to assemble storage
cabinet in steps 1-6.
NOTE: Assemble unit on a smooth, non-marring
surface to prevent scratching. Check that all
parts are included.
IMPORTANT! Turn cam lock 1/4 to the right to
lock. Ensure the arrow is pointing towards edge
of panel before inserting into the panel's hole.
IMPORTANT! FUNCTION OF CAM LOCK
Ensure the arrow is pointing towards edge of
panel before inserting into the panel's hole.
IMPORTANT! Cam lock pins must be tightened
once inserted into panel.
NOTE: Use a Phillips head screwdriver to tighten
cam locks, cam lock pins and screws.
NOTE: Cam lock caps (J or L) can be applied
once cam locks are tightened for a finished
look.
IMPORTANT! Some parts are labeled with the
same letters for the cabinet and pedestals.
Refer to the figure associated with each step to
verify the correct parts to use.
PAGE 2 OF 15
PEDESTAL PARTS
B
Handle x 4 M4 x 22 mm
Screw x 8
Key x 2
1/4 RIGHT TURN
FOR LOCKING
C
Bar Clip x 8
F
M6 x 40 mm
Screw x 8
ASSEMBLY
1. Install one cam lock pin (A) in back panel (1). Insert
one cam lock (B) into corresponding hole in bottom
panel (2). Fit back panel and bottom panel together
and turn cam lock clockwise until it locks.
(See Figure 1)
Figure 1
2. Install one cam lock pin (A) in bottom panel (2).
Insert one cam lock (B) into corresponding hole in
skirt panel (3). Fit bottom panel and skirt panel
together and turn cam lock clockwise until it locks.
(See Figure 2)
Figure 2
G
Screw x 8
#4.5 x 1 3/8"
2
1
3
1
D
Metal Bar x 4
B
J, L
A
A
J, L
B
1121 IH-8224