Uline H-8224 Instrucciones De Montaje página 4

8. Mount floor glides (A) on bottom of pedestal file.
Glides can be adjusted to compensate for uneven
floors.
9. Remove handle (B) mounted inside drawer and use
same screws to attach handle to front of drawer.
Repeat for second drawer. (See Figure 7)
10. Attach two bar clips (C) to sides of drawer and insert
metal bar (D). (See Figure 7)
Figure 7
D
C
11. Repeat steps 8-10 for second pedestal file. Place
one pedestal file on each side of storage cabinet.
(See Figure 8)
Figure 8
NOTE: Position pedestal files and storage
cabinet where intending to use credenza – it is
difficult to move when fully assembled.
Open carton H-8225 to mount credenza top.
PAGE 4 OF 15
ASSEMBLY CONTINUED
Tighten
B
C
12. Align L-bracket from lock set (G) with holes in
credenza top. Use two M3 x 14 mm screws (I) to
secure. (See Figure 9)
Figure 9
Credenza Top
13. Open top drawer of pedetal file and locate plastic
tab on drawer slides. Push up on one tab and
push down on opposite tab to release drawer and
remove. Repeat with second pedestal file.
14. Place credenza top (6) on top of storage cabinet
and pedestal files. Use 10 M6 x 40 mm screws
(M) to secure. (See Figure 10)
Figure 10
Credenza Top
NOTE: Storage cabinet comes with six
M6 x 40 mm screws (M). Each pedestal file
comes with four M6 x 40 mm screws (F). Four
screws will be left over.
Tighten
I
G
Top Drawer
1121 IH-8224