SICK SLT Instrucciones De Operación página 15

8.2.1.2.2 Configuration page
8026183 / 2021-04-29 | SICK
Subject to change without notice
NOTICE
For writing process data on the status side, at least SOPAS ET version V2021.2 is
required. Alternatively, an IO-Link master can be used to write the process data.
The following process data can be set:
• Signal lamp mode
The configured LED groups as well as the SLB buzzer can be switched on and off
via the switches.
• Filling level mode
Here the text field can be used to specify the filling level value in 0-100% format,
which is transmitted cyclically to the SLT as process data. The SLB buzzer can also
be turned on and off with a switch here.
•
Animation mode
In this mode, the animation can be switched on and off. The animation can also
be reset and its speed can be adjusted. The SLB buzzer can also be turned on and
off with a switch here.
The Configuration page is divided into four tabs:
• General
• Color
• Buzzer
• Alarm
General tab
In the GENERAL tab, the SLT can be completely shut off. In addition, the brightness of
the lamp can be adjusted. The slider can be used to set values between 0 and 100%
in 10% increments. The Find me function can also be activated here. If this function is
activated, the IO-LINK LED in the lower part of the SLT starts flashing with a frequency
of 1 Hz (clock/pause 50%) until the button is clicked again. This function can be used
to identify devices that have already been mounted.
Color tab
The appearance of the lamp can be configured in the COLOR tab. The operating modes
described in chapter 3.4 are available. Configuration is done by selecting the different
options such as color, light pattern and frequency from the CONFIGURATION OF COLOR
8
OPERATION
15