Troubleshooting; Disassembly And Disposal; Maintenance - SICK SLT Instrucciones De Operación

9

Troubleshooting

10

Disassembly and disposal

11

Maintenance

8026183 / 2021-04-29 | SICK
Subject to change without notice
The Troubleshooting table indicates which measures are to be taken if the device stops
working.
Table 4: Troubleshooting
LED indicator/fault pattern
Off
The device must be disposed of in line with applicable country-specific regulations.
When disposing of them, you should try to recycle them (especially the precious met‐
als).
NOTE
Disposal of batteries, electrical and electronic devices
• In accordance with international regulations, batteries, rechargeable batteries and
electrical and electronic devices must not be disposed of with household waste.
• The owner is required by law to dispose of these devices at the appropriate public
collection points at the end of their service life.
•
WEEE: This symbol on the product, its packaging or in the document
indicates that a product is subject to the specified regulations.
SICK devices are maintenance-free.
We do, however, recommend that the following activities are undertaken regularly:
• Clean the device
• Check the fittings and plug connectors
Use a soft cloth moistened with water to clean the device.
Do not use thinners, gasoline or oil.
In case of failure or damage of the SLT caused by aggressive media, no claims for
defects can be asserted.
No modifications may be made to devices.
Subject to change without notice. Specified product properties and technical data are
not written guarantees.
Cause
No voltage or voltage below
the limit values
Voltage interruptions
Device is defective
TROUBLESHOOTING
Measures
Check the power supply,
check all electrical connec‐
tions (cables and plug connec‐
tions)
Ensure there is a stable power
supply without interruptions
If the voltage supply is OK,
replace the device
9
19