Motorola IMPRES Serie Manual De Instrucciones página 15

During the reconditioning process, the battery becomes fully discharged. As a
result, the radio may not function during reconditioning mode.
In some cases, such as use near fluorescent lighting or electric motors, a slight
hum may be noticed in the receiving radio. If this occurs, moving the charger or
repositioning the power cord should eliminate the hum.
When troubleshooting, always observe the charge indicator – Refer to Table 3 on
page 9.
Problem What it means...
No charger 1a. Charger contact is not
indication
1b. No power to the charger.
Flashing Red 2a. Charger contact is not
Indication
2b. Battery is unchargeable.
Flashing Yellow 3.
Indication
Table 4. Troubleshooting
being made.
being made.
Battery is waiting to
charge. The battery
temperature may be
below 5°C (41°F) or
above 40°C (104°F) or
the battery voltage may
be lower than the
predetermined threshold
level for rapid charging.
13
What to do...
1a. Check that the radio with battery,
or the battery alone, is inserted
correctly.
1b. Make sure that the power cord is
securely plugged into the
charger and an appropriate ac
outlet, and that there is power to
the outlet.
2a. • Remove the battery from the
charger and replace it back
into the charger.
• Verify that the battery is a
Motorola authorized battery
listed in Table 1. Other
batteries may not charge.
• Remove power from the
battery charger and, using a
clean dry cloth, clean the gold
metal charging contacts of
both the battery and the
charger.
2b. Replace battery.
3. When this condition is corrected,
the battery will begin charging.