Charging Indicator - Worx WA3743 Manual Original

SYMBOLS
Read the operator's manual.
Warning
For indoor use only
Double insulation
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
6
or retailer for recycling advice.
Fuse
Positive terminal
Negative terminal
CHARGING PROCEDURE
NOTE: Before using the tool, read the instruction
book carefully.
1. CHARGING YOUR BATTERY PACK
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off by
means of a protective circuit: The tool no longer rotates.
In a warm environment or after heavy use, the battery
pack may become too hot to permit charging. Allow time
for the battery to cool down before recharging.
2. BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must charge
once before use.
3. HOW TO CHARGE YOUR BATTERY PACK (See
Fig. A, B)
Connect the battery charger to the power supply.
Slide the battery pack into the charger to make the
connections. The light (1) will become green and flash to
show charging has started.
After charging, the light will not flash and stay green,
which means the battery is full, and charging is completed.

CHARGING INDICATOR

This charger is designed to detect some problems that can
arise with battery packs. Indicator lights indicate problems
(see table below). If this occurs, insert a new battery
pack to determine if the charger is OK. If the new battery
charges correctly, then the original pack is defective and
should be returned to a service center or recycling service