Product-Dependent Symbols; Symbols On The Product; Product Information; Declaration Of Conformity - Hilti SID 4-A22 Manual Del Usuario

1.3 Product-dependent symbols

1.3.1 Symbols on the product

The following symbols are used on the product:
Rated speed under no load
Revolutions per minute
Direct current (DC)

1.4 Product information

Hilti products are designed for professional use and may be operated, ser-
viced and maintained only by trained, authorized personnel. This personnel
must be informed of any particular hazards that may be encountered. The
product and its ancillary equipment can present hazards if used incorrectly
by untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are stated on the rating plate.
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to inquire about the product.
Product information
Impact screwdriver
Generation
Serial no.

1.5 Declaration of conformity

We declare, on our sole responsibility, that the product described here
complies with the applicable directives and standards.
declaration of conformity can be found at the end of this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistraße 6 | 86916
Kaufering, DE
2 Safety

2.1 General power tool safety warnings

WARNING
Read all safety warnings and all instructions. Failure to follow the warnings
and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
Work area safety
▶ Keep work area clean and well lit. Cluttered or dark areas invite
accidents.
Printed: 27.09.2016 | Doc-Nr: PUB / 5293888 / 000 / 01
All manuals and user guides at all-guides.com
SID 4-A22
01
A copy of the
English 15