Kärcher FR 30 Me Manual De Instrucciones página 10

Operating Instructions
Nozzle kit assembly
Fig. 1
Note:
Observe sequence!
¾ Insert O-ring in groove of
rotation arm
¾ Plug-on nozzle
¾ Screw nozzle not too tight with
union nut
Fig. 2
Warning!
The discharge jet must be aligned
parallel to the rotation arm
¾ Align spanner-grip surface of
the nozzle (width across
flats 10) parallel to rotation arm
¾ Tighten union nut (width across
flats 22) with a spanner
Cleaning floors
Fig. 3
¾ Connect steel pipe of high
pressure cleaner to the FR 30
and tighten it with a spanner
(width A/F 24)
Cleaning walls
Preparation for
siphoning-off water
Note:
A suction device or a drain hose
can be connected with the
provided suction drain fitting
Removing the wheel set
(as required)
Fig. 4
¾ Do not remove swivel casters
from bracket
¾ Unscrew bracket from unit
¾ Refasten screws to the unit
(stabilisation of the bristles)
FR 30 Me
Installing the suction
fitting
Fig. 5
¾ Pull off cover
Fig. 6
¾ Fasten the suction fitting with
the supplied screws and nuts
High-pressure cleaner
connection
Fig. 7
¾ Disconnect angle joint from unit
(width A/F 27)
¾ Screw on handgun directly
¾ Tighten union nut with a
spanner
Siphoning-off water
options
Hose connection
Fig. 8
¾ Fasten hose with hose clamp to
suction fitting
Fig. 9
¾ Hold the unit at the centre
support
English
¾ Ensure that the hose hangs
down vertically
Siphon connection
Fig. 10
¾ The cover must be removed in
order to prevent a vacuum
developing
Fig. 11
¾ Connect hose of the siphon to
the suction fitting
Note
See accessory page for coupling
sleeves
Fig. 12
¾ Hold the unit at the centre
support
¾ Ensure that the hose hangs
down vertically
Care
protect from frost
Lubricate swivel casters
regularly
Ensure bristles are not
deformed during storage
10