Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
If your measurement is greater than the
E
8.
Allowable Distance Between
corresponding Distance Between Walls in the
following table, the laser must be serviced at an
authorized service center.
Distance
Between Walls
30' (9m)
40' (12m)
50' (15m)
Horizontal Beam - Pitch Direction
Checking the horizontal pitch calibration of the
laser requires a single wall at least 30' (9m)
long. It is important to conduct a calibration
check using a distance no shorter than the
distance of the applications for which the tool
will be used.
Place the laser against the end of the wall
1.
(Figure
E 1
Move the Power/Transport Lock switch to
2.
the right (Figure
self-leveling mode and display the horizontal
and vertical beams.
At least 30' (9m) apart along the laser
3.
beam, mark
Move the laser to the opposite end of the
4.
wall (Figure
Position the laser toward the first end of the
5.
same wall and parallel to the adjacent wall.
Adjust the height of the laser so the center
6.
of the beam is aligned with
Directly above or below
7.
the laser beam (Figure
12
and
a
Allowable Distance
Between
a
7/16" (11.0mm)
9/16" (14.4mm)
23/32" (18.0mm)
).
) to turn the laser ON in
A 3
and
.
a
b
).
E 2
.
b
, mark
a
).
E 3
Measure the distance between
8.
for the
b
If your measurement is greater than the
9.
Allowable Distance Between
the corresponding Distance Between
and
be serviced at an authorized service center.
and
b
Distance Between
Vertical Beam - Plumb
Checking the vertical (plumb) calibration of the
laser can be most accurately done when there is
a substantial amount of vertical height available, ideally
30' (9m), with one person on the floor positioning
the laser and another person near a ceiling to mark
the position of the beam. It is important to conduct
a calibration check using a distance no shorter than
the distance of the applications for which the tool will
be used.
On the floor between two walls, mark a 5 ft. (1.5
1.
m) line that is parallel to the adjacent wall (Figure
F 1
Move the Power/Transport Lock switch to the right
2.
(Figure
mode and display the horizontal and vertical beams.
Place the laser at one end of the line on the floor,
3.
making sure the vertical laser beam is aligned and
centered on the line.
Where the vertical laser beam appears on the
4.
ceiling, mark
midpoint of the line on the floor.)
Move the laser to the other end of the line on the
5.
along
c
floor (Figure
in the following table, the laser must
b
Allowable Distance
and
Between
a
b
30' (9m)
7/16" (11.0mm)
40' (12m)
9/16" (14.4mm)
50' (15m)
23/32" (18.0mm)
).
) to turn the laser ON in self-leveling
A 3
. (This should be directly over the
a
).
F 2
and
.
a
c
and
for
a
c
a
and
a
c
Publicidad
Tabla de contenido
