DeWalt DW7463 Manual De Instrucciones página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Items Included
• (1) DW7463 Outfeed table sub-assembly
• (1) Hardware bag
Tools needed
• (2) 16mm or 5/8" open end wrenches
• Ruler
• Soft hammer, or regular hammer and block of wood
To speed assembly, the following would be helpful:
• 16mm or 5/8" socket wrench
Necessary Hardware
The included hardware bag contains all the necessary
nuts, bolts, and washers to assemble the components
included with the DW7463 Outfeed Table and to attach it
to the DW746 Woodworker's Table Saw (When attaching
as an add-on use new hardware in place of removed hard-
ware).
To make assembly of your saw/accessory easier, match
the nuts, bolts, and washers with the hardware chart.
Before each step, check your hardware against the chart
and identify the pieces you need.
Table saw Preparation: If you purchased the Outfeed
Table as an add-on accessory, start with this section. If
you purchased your Outfeed Table with your DW746
Woodworker's Table Saw, skip to the assembly section.
• If you have no other accessories (52" Rail System or
Slide Table) on your saw, remove the rear rail and
associated hardware...
• ...OR with another accessory in place remove the rear
support brackets (Fig. 1) from between the saw table
and the rear rail. Do not remove the rear rail.
• Continue with Assembly, starting at Step 14.
FIG. 1
Hardware Included with the
DW7463 Heavy Duty Outfeed Table
BOLT
BOLT
10 MM X 25 MM
10 MM X 35 MM
(6 PIECES)
(4 PIECES)
FLAT WASHER
(10 PIECES)
10 MM LOCK WASHER
(10 PIECES)
M 10 NUT 16 mm HEX
(10 pieces)
Carriage Bolt
10 mm x 20 mm
(2 pieces)
10 mm WING NUT
(2 pieces)
Assembly
If you have other accessories (Slide Table and/or 52" Rail
System) completely assemble them first. Then return to
this manual to complete Outfeed Table Assembly, starting
at step 14.
PLEASE READ ENTIRE ASSEMBLY SECTION
BEFORE PROCEEDING.
STEP 1. Remove parts box, motor cover, fence beam, and
side tables from saw packaging.
STEP 2. Turn the saw right side up. You will need help.
The combined weight of the table top and motor is
approximately 200 lbs.
STEP 3. Cut and remove plastic strap holding the motor.
STEP 4. Using front hand crank, lower the motor some
and remove the foam packing material between the
motor and the mechanism.
STEP 5. Install bevel crank (Fig. 2). To do this, first
install the crank handle (A) over the shaft (B), rotate
slightly to fully engage the shaft pin. Screw the lock
knob (C) into place until it is fully seated, then back it
off 1/4 to 1/2 turn.
FIG. 2
A
B
C
STEP 6. Using height crank, raise mechanism up as high
as it will go.
STEP 7. Install wrench hook (Fig. 3). On the front right
leg, near the top is a plastic threaded insert. Thread
the "L" shaped wrench hook in until no threads are vis-
ible.
FIG. 3

Publicidad

Tabla de contenido
loading

Tabla de contenido