Additional Information - DeWalt DW7463 Manual De Instrucciones

Additional Information

Removal and Storage:
• The outfeed table can be easily taken off by removing
the carriage bolts and wing nuts. Remove the outfeed
table from the back of the saw. Fold leg set down, lock-
ing into place, and table is ready for storage. Replace
hardware into hanger brackets for safe keeping
Cleaning:
• The table board of your Outfeed table is a composite
material, excessive moisture can cause deterioration.
Cleaning with a damp cloth or a mild solvent on the top
surface is acceptable, but the edges of the board
should not be wetted.
Adjust the rear fence glide
If necessary, adjust the rear glide to locate it correctly
against the rear rail by loosening the two screws which
secure it to the fence beam. The plastic retaining clip
should be deflected somewhat when the glide is posi-
tioned correctly. This adjustment should only be neces-
sary if the rear rail has been relocated by the addition of
an optional accessory.