Removing Jammed Paper - Epson TM-U220 Manual Del Usuario

English
Troubleshooting
Printing stops before all the lines are printed or the printer prints the same line
repeatedly
If the correct power supply unit is not used, the printer cannot operate
correctly. Make sure the correct power supply unit is connected to the
printer, referring to the table below:
The power supply unit that can be used with the TM-
U220 alphanumeric model (types A, B, and D)
"AC adapter, C", "AC adapter, C1" or "PS-180"
*Multilingual means the printer model that can print any one of the following: Japanese Kanji, Simplified
Chinese, Traditional Chinese, Thai characters, or Korean characters.
No lights on the control panel
Check the power supply cable connections and the power outlet.
ERROR (ERROR) LED is flashing or lit
❏ The print head temperature may be too high or low. Wait until the
print head cools or warms and the printer resumes printing
automatically.
❏ Make sure that the roll paper cover is properly closed.
❏ Types A and B: The autocutter blade is not in the normal position and
the autocutter is locked up. If it is a simple lock-up, the error is
corrected automatically. If not, see the instructions below to return the
blade to the normal position manually.
❏ A paper jam has occurred. To remove the jammed paper, see the
instructions below.
❏ Turn off the power, wait several seconds, and then turn it on again. If
the error remains, contact your supervisor or a qualified service person.
Returning the autocutter blade to the normal position
1. Open the roll paper cover by using the tab, as shown in illustration H.
2. Use a ballpoint pen or tweezers to turn the knob of the autocutter in
the direction indicated by the arrow until you see a round shaft in the
hole, as shown in illustration P.

Removing jammed paper

The print head becomes very hot during printing. Allow it to cool before you reach into the
printer.
8 TM-U220 User's Manual
CAUTION:
The power supply unit that can be used with the TM-
U220 multilingual* model (types A, B, and D)
"PS-180" or "AC adapter, C1"