Replacing Main Burners; Ignition System Operations - Weber Q 300 Guia Del Propietario

24

REPLACING MAIN BURNERS

®
1) Your Weber gas barbecue must be OFF and cool.
2) Turn gas OFF at source.
3) Open lid and remove the cooking grates.
4) Remove nut and washer on Outside burner and Inside burner.
5) Rotate the outside burner 90º clockwise. Slide and lift burner away from
burner orifi ce and remove from cook box.
6) Repeat this procedure for the Inside burner.
CAUTION: Care must be taken when removing or
reinstalling burner tubes. Do not force or bend the
gas lines that connect the burner tubes to the control
valve.
7) To reinstall the burners, reverse 4) through 7).
CAUTION: The burner openings(a) must be
positioned properly over the burner orifi ces(b).
Check for proper assembly before fastening Burner tubes in place.
WARNING: After reinstalling the burners, the gas
connections should be leak checked with a soap and
water solution before using the barbecue. (See Step:
"Check for gas leaks.")

IGNITION SYSTEM OPERATIONS

If the ignition system fails to ignite the burners, then check the igniter.
• Check that both ignition wires are attached properly to igniter
electrodes(1).
• Check that the ignition button pushes in, and returns to the up position.
If the ignition system still fails to light, contact the Customer Service
Representative in your area using the contact information on our web
site. Log onto www.weber.com
(1)
Maintenance
® .
(1)
(a)
(b)