Replacing Rear Wheel Handrims; Front Riggings; A.swing-Away Footrest Assembly Installation; B.swing-Away Footrest Height Adjustment - Sunrise Medical Breezy Manual De Instrucciones

20
E. REPLACING REAR WHEEL HANDRIM (FIGURE 6)
1. Remove the rear wheel from the wheelchair.
2. Remove the nuts (A) and washers that secure the handrim to the rear wheel.
3. Remove existing handrim.
4. Install the new handrim by reversing steps 1, 2, 3.
5. Repeat the procedure for the opposite rear wheel if necessary.
After ANY adjustment, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely – otherwise injury or damage may result.
A. SWING-AWAY FOOTREST ASSEMBLY INSTALLATION (FIGURE 7)
1. Turn the footrest to the side (open footplate is perpendicular to wheelchair).
2. Install the footrest hinge plates (B) onto the hinge pins (C) on the wheelchair frame.
3. Push the footrest toward the inside of the wheelchair until it locks into place.
Note- the footplate will be on the inside of the wheelchair when locked in place.
4. Repeat this procedure for the other footrest assembly.
5. To release the footrest, push the footrest release lever (D) inward, rotate footrest
outward and off the hanger pins.
B. SWING-AWAY FOOTREST HEIGHT ADJUSTMENT (FIGURE 8)
NOTE-
Release the footrest locking mechanism and lift the footrest off the hinge pins. Lay the assem-
bly on a flat surface to simplify this process.
1. Release Velcro heel loop (E) and lay to the side.
2. Rotate release lever (F) downward so its perpendicular to foot extension tube.
3. Push detent pin in (G) and adjust to desired height.
4. Once desired height is achieved, ensure that detent pin (G) is fully engaged and back
in normal position.
5. Return release lever (F) back to locked position. Pictured in Figure 8.
6. Reattach Velcro heel loop in secure position.
C. ELEVATING LEGREST ASSEMBLY INSTALLATION (FIGURE 9)
1. Place legrest assembly on the outside of the wheelchair and install the hinge plates
(H) onto the hinge pins (I) on the wheelchair.
2. Rotate the legrest assembly toward the inside of the wheelchair until it locks in
place. Figure 9 shows a locked elevating legrest assembly.
3. Repeat this procedure for the other legrest assembly.
4. To release the legrest, push the legrest release handle (J) toward the inside of the
wheelchair (facing the front of the wheelchair) and swing the legrest assembly to the
outside of the wheelchair.
D. ADJUSTING THE ELEVATING LEGREST ASSEMBLY (FIGURE 10)
1. To adjust the elevating legrest, raise the legrest until the desired height is obtained.
2. To reposition legrest, support leg with one hand and push release lever (K) downward
with other hand.
3. To adjust the calf pad, turn towards outside of wheelchair and slide up or down to
one of three pre-configured slots (L). To adjust the depth of the calf pad, loosen the
calf pad bolt (M) and retighten at desired position.
4. To adjust the length of the elevating legrest, loosen but don't remove the bolt and
locknut (N) that secure the lower footrest assembly to the upper footrest assembly.
Obtain desired position and secure bolt.
930853 Rev. B
E n g l i s h

FRONT RIGGINGS

WARNING
I X . S e t - U p , A d j u s t m e n t & U s e
I
J
6
A
7
B
D
C
8
G
E
F
9
H
10
K
L
M
N