B.installing/Replacing Front Casters; Replacing Front Caster Tire; Anti-Tippers - Sunrise Medical Breezy Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I X . S e t - U p , A d j u s t m e n t & U s e
B. INSTALLING/REPLACING FRONT CASTERS (FIGURE 19)
1. Remove the dust cover (G).
2. Remove the locknut and nylon washer inside the caster journal that secure the fork to
the caster head tube (H).
3. Drop the fork out of the caster head tube.
4. Slide the new fork into caster head tube and reassemble by reversing STEPS 1-3.
5. Removing fork provides access to to the caster bearings so they can be replaced.
6. Whenever there is an adjustment to the seat-to-floor height (STFH), the angle of the
caster journal should be checked to make sure its leading edge is perpendicular to
the ground. Perpendicular orientation will guard against flutter.
C. REPLACING FRONT CASTER TIRE (FIGURE 20)
Replacement of the front caster tire MUST be performed by a qualified technician
1. Remove hex bolt hardware (I) that secures the front caster tire (J) to the fork (K).
2. Install the new front caster tire onto the wheelchair by reversing STEP 1.
3. Repeat STEP 1-2 for the opposite front caster tire.
CAUTION- As with any vehicle the wheels should be checked periodically for cracks and
wear, and should be replaced.
(FIGURE 21)
After ANY adjustment, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely – otherwise injury or damage may result.
The manufacture strongly recommends ordering the anti-tippers as an additional safeguard
for the wheelchair user.
Anti-tip tubes prevent a wheelchair from tipping over backward when properly installed.
Anti-tippers must be fully engaged. Ensure the release button (A) of the anti-tipper fully
protrudes out of the hole on the bottom of wheelchair frame when installing.
An interval of 1 to 2 inches (2.5 mm to 5mm) should be maintained between the anti-tip
tubes and the ground. Use the release button (B) to make needed adjustments.
Ensure both anti-tippers are adjusted to the same height.
WARNING
ANTI-TPPERS
WARNING
E n g l i s h
K
I
J
A
B
23
20
21
930853 Rev. B

Publicidad

Tabla de contenido
loading

Tabla de contenido