Carrier 40VCB217FQEE Manual De Instalación Y Propietario página 15

Software Operation instructions
Success messages will be given as follows after the command is sent
In the operation view, you can set the working mode, set the temperature, set the fan speed, select ON/OFF, and select the
control mode, which has three options: LIFO, central control, and force control.
LIFO Central control Force control
LIFO: the wired controller or remote controller can normally control any parameters of the indoor unit
Central control: the wired controller or remote controller can only switch the indoor unit ON/ OFF; other parameters cannot
be controlled.
Force control: the wired controller or remote controller cannot control the indoor unit.
3. Floor navigation interface
If you configure the floor navigation interface, in the monitoring management, the already configured floor navigation interface
can be viewed. In the floor navigation interface, you can view the current state or control indoor operating parameters. The
configuration of the floor navigation interface refers to steps in 3.5.3 floor map configuration.
13