Hose & Regulator Specifications And Installation - Brinkmann 810-6340-S Manual Del Propietário

LP GAS CYLINDER (TANK) RUBBER SEAL INSPECTION:
• Inspect the propane tank valve rubber seal for cracks,
wear or deterioration prior to use. A damaged rubber
seal can cause a gas leak, possibly resulting in an
explosion, fire or severe bodily harm.
• Inspection should be done each time the propane tank
is connected to the grill, has been refilled, exchanged or
has not been used for more than 60 days.
• Do not use a propane tank with a damaged rubber seal.
Exchange the tank or have the rubber seal replaced at a
qualified propane filling station.
INSTALLING THE LP GAS CYLINDER (TANK) ONTO THE GRILL:
1. Check that the cylinder valve is closed by turning the knob clockwise.
2. Place the cylinder into the tank holder on the bottom of the left brace. Then slide tank brace over
cylinder handle and secure tightly.
3. Orient the cylinder such that the valve opening faces the front of grill and so that the hose is not
kinked or damaged.
4. Make sure tank sits securely in tank holder.
SPECIFICATIONS AND INSTALLATION:
• DO NOT attempt to connect grill, as purchased for LP (propane) gas, to any other fuel supply
source such as a natural gas line. A Brinkmann conversion kit must be purchased and installed
for use with natural gas.
• Do not use any other pressure regulator/hose assembly other than the one supplied with your
grill. Replacement pressure regulator/hose assembly must be part No 155-6340-0, which can be
obtained by contacting customer service at 800-527-0717.
• Do not attempt to adjust or repair a regulator. The regulator is designed to operate at a
maximum output pressure of 11 inches of water column (2.74 kPa).
• Ensure the tank valve is closed prior to connecting the LP gas cylinder to your grill. Turn the
valve knob clockwise to properly close the valve. Read and follow all instructions and warnings
on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe
use of LP gas cylinders and the hose and regulator before connecting cylinder to grill. Read and
follow all warnings on the LP cylinder.
Tank Brace
Tank Holder
HOSE & REGULATOR
WARNING
Good
Rubber Seal
Damaged
Rubber Seal
6