Reese 30180 Instrucciones De Instalación página 3

Pickup Bed Preparation
NOTE:
Read this entire section before drilling to reduce risk of damage to pickup bed.
1. Locate the dimples in the bed floor. These indicate the center of the holes to be drilled that will allow the 5
mounting pucks and gooseneck to pass through the pickup bed.
Using a 3" hole saw cut the 4 outer puck holes (See Figure 3).
2.
Using the 4 ¼" hole saw cut the center gooseneck hole (See figure 3).
3.
4. Deburr the rough edges of the 5 drilled holes.
5. Apply corrosion preventative to raw edges of drilled holes.
©
2019,2020 Horizon Global Page 3 of 24
Printed In Mexico
FIGURE 3
30180N 04/30/20
th
wheel hitch
Rev. B