Reese 30180 Instrucciones De Instalación página 6

Pickup Bed Installation
1. Install pickup bed
•
Ensure the locating bolts shown in figure 7 are properly installed to both the pickup frame and pickup
bed to prevent misalignment.
2. Tighten the eight bolts to 129 ft-lbs (175 Nm).
FIGURE 7
3. Install the fuel filler pipe and tighten to 44 in-lb (5 Nm).
4. If equipped, install the urea filler pipe and tighten to 22 in-lb (2.5 Nm).
5. Reconnect the LH and RH wire harnesses.
6. Install the tailgate onto the pickup bed.
7. While inside the pickup bed, inspect the fifth wheel hitch for proper puck placement.
•
Puck grooves should sit above the drilled holes.
• There should be a minimum 0.039" (1mm) clearance between the pucks and holes in the pick up bed.
FIGURE 8
8. Clean any debris from pickup bed
9. Check the vehicle exterior lighting for proper operation.
©
2019,2020 Horizon Global Page 6 of 24
Printed In Mexico
30180N 04/30/20 Rev. B