General Safety Instructions For The Pole-Mounted Pruner - Grizzly Tools AKHS 20 Set Traducción Del Manual De Instrucciones Origina

misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
Keep cutting tools sharp and clean.
•
Properly maintained cutting tools with
sharp cutting edges are less Iikely to
bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed. Use
of the power tool for operations differ-
ent from those intended could result
in a hazardous situation.
• Carefully inspect the area to be cut
and remove all wires or other foreign
bodies.
• Hold the power tool by insulated grip-
ping surfaces only, because the cut-
ter blade may contact hidden wiring
or its own cord.
Careful handling and use of battery
devices.
Charge the batteries only in charg-
•
ers that are recommended by the
manufacturer. Risk of fire if a charg-
er that is suitable for a specific type of
battery is used with other batteries.
• In the power tools, use only the
batteries designed for the pur-
pose. The use of other batteries may
result in injuries and risk of fire.
Keep the unused battery away
•
from paper clips, coins, keys,
nails, screws and other small
metal objects, which could cause
bridging of the contacts. A short
circuit between the battery contacts
may cause burns or fire.
If used incorrectly, liquid may leak
•
from the battery. Avoid contact
with this. In the event of accidental
contact, rinse off with water. If the
liquid gets into eyes, seek medical
assistance. Leaking battery fluid may
cause skin irritations or burns.
Service
Have your power tool serviced by
•
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
General safety instructions
for the pole-mounted pruner
• Keep the equipment, cutting attach-
ments and protective blade cover in
good condition in order to prevent injury.
• Ensure during any location change that
the saw chain is secured with the chain
brake and the chainsaw is switched off
and the finger does not contact the On/
Off switch. Carry the cordless pruner
with the chain and chain bar pointing
to the rear. Attach the chain guard for
transporting the cordless pruner. If
dropped, check the equipment for sig-
nificant damage or defects.
• Never start the cordless pruner be-
fore the chain bar, saw chain and
sprocket chain wheel covering are
correctly assembled.
• The cordless pruner is designed for
two-handed operation. Never work with
one hand or above shoulder height.
• Hold the power tool only on the in-
GB
67