Tork E500T Manual De Instrucciones página 3

E500T
MODEL#:
The E500T is an ON delay timer which allows for a set time interval to elapse before the load connected to the timer is powered ON. An external maintained contact switch (by others) is used to start the
delay time. Once turned ON, the load will remain on until the external switch is opened.
It has an adjustable rotary dial which contains 32 precisely defined positions, allowing for interval durations from five (5) seconds minimum to 3 hours maximum. Continuous ON and continuous OFF
settings are included.
POWER
Input: 120 and 240 VAC (+10% -15% at 60 Hz).
REQUIREMENTS:
Outputs: SPDT relay with 20 Amp N.O. and 10 Amp N.C. general purpose at 120,240 VAC; N.O. 1 HP at 120 VAC, 2HP at 240 VAC
Operating Temperature Range: 32°F to 122°F (0°C to 50°C). Operating Humidity Range: Relative humidity up to 100%
ENVIRONMENTAL:
Water Resistance: The control will be capable of direct low-pressure water wash down according to NEMA 4X specification.
CONTACT
RATING:
ENCLOSURE:
NEMA type 4X (indoor use only) enclosure standard (E500T). Watertight cover with gasket - flame retardant UV stabilized & non-metallic. In grey.
MOUNTING:
Control is compatible for mounting to Tork's NEMA 4X nonmetallic enclosure.
DIALS:
Sealed from external access
MAINTENANCE:
Cleaning: Use only mild detergent and water to clean the enclosure
INSTALLATION & WIRING INSTRUCTIONS
Note: Wiring connections are made to a six-position terminal block.
All terminals accept AWG #18 to AWG #12 wire.
1. Turn off all power to the timer circuit at the distribution panel before
beginning the installation.
2. The E500T box contains knockouts on two sides. Determine the most
convenient way to mount the box to the conduit and remove the appropri-
ate knockout. To secure the box to a fixed location, use at least two of the
four box mounting knockouts located on the back of the box.
3. Wire timer for either 120 VAC or 240 VAC as shown by the wiring dia-
gram. Wire the load to the timer as shown in the wiring diagram, noting
the contact load type and ratings shown.
4. Connect external trigger contacts to the timer as shown in the wiring
diagram.
5. Securely attach the timer to Tork's NEMA 4X (for indoor use only) non-
metallic enclosure with the included screws
ON DELAY TIMER
VOLTAGE LOAD TYPE
120-240 VAC Resistive
120-240 VAC General Purpose
120 VAC
208-240 VAC
120-240 VAC Pilot Duty
N.O. CONTACTS
Motor
Motor
or servicing this lighting control or the equipment connected to it.
TRIGGER
START
EXTERNAL
TRIGGER
(CONTACTS)
20 A
20 A
1 HP
2 HP
470 VA
! CAUTION !
RISK OF ELECTRIC SHOCK
Disconnect power at main panel prior to installing
SPDT
NC NO COM
LOAD
120V
N L
FOR 120V
(L)
L2 L1
FOR 240V
FOR 240V
(L1)
N.C. CONTACTS
10 A
10 A
¼ HP
½ HP
275 VA
T
240V/L1 120V NEUT/L2
120V
L N
L1 L2
FOR 240V
APPLY ONLY ONE VOLTAGE