Uline H-279 Manual De Instrucciones

H-279
DELUXE STEEL
STRAPPING CART
LOAD NEW COIL OF STRAPPING
NOTE: Instructions apply for loading a 16"
diameter core of steel strapping.
1. Lay the dispenser down on its back and loosen the
wing nut by turning it counter-clockwise.
2. Remove the wing nut and the front reel disc
assembly.
NOTE: Observe the pay-off direction of the
lead end. When the coil is mounted, the
lead end should point toward the brake arm
strap guide. As the strap is used, the coil and
flanges will rotate clockwise.
3. Place a new coil of strapping on the dispenser.
CAUTION! Steel strapping is heavy. Use proper
lifting techniques to avoid personal injury.
Always wear gloves when handling steel
strapping.
4. Align and center the larger coil core and lower the
new coil over the central hub, allowing it to settle
over the smaller circular indentation on the hub reel
disc.
5. Cut and remove the tie closest to the lead end of
the strapping.
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
6. Thread the lead end through the brake arm strap
guide.
7. Cut and remove the remaining ties. Replace the
front reel disc with the core indentation facing
inward so that the indentation fits into the core of
the coil. The flat face of the front reel assembly
should be facing outward.
8. Place the front reel disc assembly on the coil.
9. Replace and securely tighten the wing nut by
turning it clockwise.
CAUTION! The wing nut must be tight to
prevent tangling of strapping.
10. When the wing nut is secure, stand the dispenser
upright. Turn the lead end back on itself over the
strap guide assembly to prevent personal injury.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0321 IH-279