Uline H-295 Manual De Instrucciones

H-295, H-518
HEAVY DUTY
HANDWRAPPER
Figure 1
TO LOAD FILM ONTO HANDWRAPPER
NOTE: Handwrappers come preset at 12"
(H-295) and 18" (H-518) height. Must unthread
completely to use larger rolls.
1. Unscrew the top knob (turn counterclockwise) about
1/2 inch. Remove the slotted top core holder by sliding
it out of the threaded rod section. (See Figure 1)
2. Slide the film roll over the top knob and position the
film core over the bottom core holder.
3. Take the top core holder and slide it back through the
threaded rod section. Drop it into the top of the core.
4. Screw the top knob clockwise until it holds the top
core holder in place.
PAGE 1 OF 3
1-800-295-5510
uline.com
LOADING AND UNLOADING INSTRUCTIONS
Knob Assembly
(Washer, Bearing,
Threaded Rod)
Top Core Holder
Top Knob
Threaded Rod
Section
Top Core Holder
(Top View)
Bottom Core Holder
TO REMOVE FILM FROM HANDWRAPPER
1. Unscrew the top knob (turn counterclockwise) about
1/2 inch. Remove the slotted top core holder by sliding
it out of the threaded rod section. (See Figure 1)
2. Remove the film by sliding it over the top knob.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0721 IH-295