Call History; Phonebook - Kenwood KDC-X702 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BLUETOOTH®
SETTINGS
AUTO ANSWER
1 to 30: The unit answers incoming call automatically in the
selected time (in seconds). ; OFF: Cancels.
BATTERY/SIGNAL*
AUTO: Shows the strength of the battery and signal when the unit
detects a Bluetooth device and the Bluetooth device is connected. ;
OFF: Cancels.
* Functionality depends on the type of the phone used.
Make a call
You can make a call from the call history, phonebook, or dialing the
number. Call by voice is also possible if your mobile phone has the
feature.
1
Press
to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
another phone.
"(Second device name)" appears.
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3
Repeat step
2
until the desired item is selected/activated or follow
the instructions stated on the selected item.
4
Press and hold
to exit.
To return to the previous setting item, press
24
ENGLISH
Default: XX

CALL HISTORY

PHONE BOOK
again to switch to
NUMBER DIAL
.
(Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone number.
• "INCOMING", "OUTGOING", or "MISSED" is shown on the lower part
of the display to indicate the previous call status.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history.
2 Press the volume knob to call.
(Applicable only if the phone supports PBAP.)
1 Turn the volume knob quickly to enter alphabet search mode (if the
phonebook contains many contacts).
The first menu (ABCDEFGHIJKLMN) appears.
• To go to the other menu (OPQRSTUVWXYZ1 ), press J / K.
• To select the desired first letter, turn the volume knob or press
S / T, then press the knob.
Select "1" to search with numbers and select " " to search with
symbols.
2 Turn the volume knob to select a name, then press the knob.
3 Turn the volume knob to select a phone number, then press the knob
to call.
• The phonebook of the connected phone is automatically transferred to
the unit when pairing.
• Contacts are categorized as: HOME, OFFICE, MOBILE, OTHER, GENERAL.
• This unit can display only non-accent letters. (Accent letters such as
"Ú" is shown as "U".)
1 Turn the volume knob to select a number (0 to 9) or character
( , #, +).
2 Press S / T to move the entry position.
1
2
Repeat steps
and
until you finish entering the phone number.
3 Press the volume knob to call.
(or using the remote control)
1 Press the number buttons (0 to 9) to enter the phone number.
2 Press
to call.

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Kdc-x502Kmr-d772btKdc-bt772hdKdc-bt572u

Tabla de contenido