Technical Specifications; General Information - Hayward HCP5000 Manual De Instrucciones

This operation manual should be read carefully before the installation process. Installation must
be in accordance with local regulations.
DESCRIPTION
These pumps are designed to recirculate clean water lightly treated in private and public
swimming pools, without abrasive or aggressive products that could damage the pump.

Technical specifications

1.1
Motor:
- Ambient temperature: 4 ° C / 40 ° C.
- Service: Continuous.
- Protection: IP 55.
- Bearing 2Z: Armored greased for life.
- Power: (See plate of the motor).
- Consumption: (See motor nameplate).
- Voltage: (See motor nameplate).
- Voltage: (See motor nameplate).
- Efficiency: (See motor nameplate).
- Nominal RPM: 1,450 or 2,850. (See nameplate of the motor).
Pump:
- Pump body: Cast iron (Bronze on request).
- Turbine type: Cast iron (Bronze on request)
- Impeller type: Closed
- Shaft: Steel AISI 316.
- Type mechanical seal: Carbon + Resin-ceramic.
- Density of liquid: 1.
- Liquid temperature: 4 ° C / 40 ° C.

GENERAL INFORMATION

2.1 Introduction
This manual contains instructions for installation, the use and maintenance of the pump. To
obtain the performance is indicated in the data pages, you must meet and correctly follow
all recommendations given in this manual. This will bring a safe and durable equipment.
The supplier of the equipment shall provide the user with additional information, if required.
2.2 Responsibility
All equipment supplied by THE SUPPLIER are duly protected to avoid accidents, but in
any case all safety recommendations outlined in the equipment, documents supplied with it
and especially the local regulations that apply must be followed.
It is the sole responsibility of the installer / user to evaluate the individual risks that exist in
each facility and not to allow the connection and start up of the equipment without the
appropriate protections.
2.3 Rules
As described in the attached documentation conforms to the European Machinery Directive
16