Important; Dishwasher Efficiency Tips - Sears Kenmore ULTRA WASH 665.1309 Serie Manual De Uso Y Cuidado

Ocultar thumbs Ver también para Kenmore ULTRA WASH 665.1309 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Filter Removal
I.
Turn the Upper Filter Assembly 1/4 turn counterclockwise
and lift out.
2.
Grasp the Lower Filter in the circular opening, lift slightly, and pull forward
to remove.
3.
Clean the filters as shown below.
Locating
tab
Filter Cleaning
IMPORTANT: Do not usewire brush, scouring pad, etc., as they may damage the filters.
Rinse filter under running water until most soils are removed. If you
have hard-to-remove
soils or calcium deposits from hard water, a
soft brush may be required.
To remove
Upper
Filter
Assembly
Filter Reinstallation
1. Noting the previous illustrations, place the Lower Filter under the Locating Tabs in the
bottom of the dishwasher so the round opening for the Upper Filter Assembly lines up with
the round opening in the bottom of the tub.
2.
Insert the Upper Filter Assembly into the circular opening in the Lower Filter.
3.
Slowly rotate the filter clockwise until it drops into place. Continue to rotate until the filter
is locked into place. If the filter is not fully seated (still turns freely), continue to turn the
filter clockwise until it drops and locks into place.
NOTE: The Upper Filter Assembly arrow does not have to align with the arrow in the
Lower Filter as long as the filter is locked.
Locating tab
To replace
Upper
Filter
Assembly
IMPORTANT: To avoid damage to dishwasher, do not operate your dishwasher without the ULTRA WASH _ÈEfilters properly installed.
Be sure the Lower Filter is securely in place and the Upper Filter Assembly is locked into place. If the Upper Filter Assembly turns
freely, it is not locked into place.
DISHWASHER EFFICIENCY TIPS
Hot water dissolves and activates the dishwasher detergent. Hot water also dissolves grease on dishes and helps glasses dry spot-
free. For best dishwashing
results, water should be 120°F (49°C) as it enters the dishwasher. Loads may not wash as well if the water
temperature
is too low.
Additional
efficiency tips
To save water, energy and time, only scrape dishes. Do not rinse dishes before putting them into the dishwasher.
Use a delay feature to run your dishwasher during off-peak
hours. Local utility providers recommend avoiding
heavy usage of
energy at certain times of day.
During the summer, run your dishwasher at night. This reduces daytime
heat buildup in the kitchen.
Use a rinse aid to improve drying.

Publicidad

Tabla de contenido
loading

Tabla de contenido