Uline H-5333 Guia Del Usuario página 4

OPERATING ISSUE
No power to machine.
Paper not pulling through head.
Paper exposed in exit shoot, but
not being pulled through with
foot pedal operation.
Paper jamming.
Paper ripping during operation.
If problems persist, please contact Uline Customer Service at 1-800-295-5510.
PAGE 4 OF 13
TROUBLESHOOTING
CAUSE
Unit not plugged in.
Motor not connected to power
box.
Machine needs to be reset.
Foot pedal not connected to
power box.
Paper wadded in entrance
funnel, not flat.
Paper is caught or not
threaded through enough.
Insufficient drive wheel tension.
Not using recommended
paper.
Restriction in the entrance or
exit funnel.
Not using recommended
paper.
Live roller on cradle is not
rolling freely.
Continuous, back-to-back,
short bursts of paper using the
pedal.
Too much drive wheel tension.
1-800-295-5510
uline.com
RECOMMENDATIONS
Connect power cord to standard 115V
outlet.
Connect blue motor connector plug to
the blue plug on the power box; make
sure it has clicked into place.
Check white two amp reset button on
power box to make sure it is recessed.
Connect the gray foot pedal connector
plug to the gray plug on the power box;
make sure it has clicked into place.
Make sure paper is flat and folded in on
itself in the entrance funnel.
Turn threading disk clockwise to advance
paper.
Tighten the bolts on the top of the head a
quarter turn at a time. Repeat as needed
until drive wheels grip paper.
Use only 30 lb. or 40 lb. kraft paper with
machine.
Unplug unit and retrieve any debris or
jammed paper from the machine by
tearing the paper from the paper ramp
and turning threading disk clockwise.
Use only 30 lb. or 40 lb. kraft paper with
machine.
Paper roll needs to be unspooled from
the rear of the paper cradle.
Use gentle foot pedal operation, avoid
stepping on the foot pedal with extreme
force.
Loosen the bolts on top of the head a
quarter turn at a time. Repeat as needed
until drive wheels are no longer ripping
the paper.
0621 IH-5333