Water Supply; Connect Water Supply; Connect High-Pressure Hose And Lance - Generac G0069240 El Manual Del Propietario

5. Install fuel cap.
NOTE: Allow spilled fuel to evaporate before
starting unit.

Water Supply

NOTE: DO NOT run unit without sufficient
water supply. Failure to follow water supply
requirements will void unit warranty.
Water supply must meet the following
requirements:
• DO NOT siphon standing water for the
water supply.
• Water temperature must be less than
100°F (38ºC).
• Water supply hose length must not exceed
50 ft (15.2 m).
• Water must be greater than 3.8 gallons per
minute (17.3 liters per minute) and no less
than 30 psi (206.8 kPa).
• DO NOT use a one-way valve, vacuum
breaker, or check valve in any part of the
water supply.

Connect Water Supply

1. Remove and discard shipping cap from
the pump water inlet.
2. Run water supply for 30 seconds prior to
connection to eliminate debris.
3. See Figure 2-10. Inspect inlet screen for
debris. Clean screen or replace as
necessary. DO NOT run power washer if
inlet screen is damaged or missing.
Figure 2-10. Inspect Inlet Screen
4. See Figure 2-11. Connect water supply
hose to pump water inlet and hand-
tighten.
.
Figure 2-11. Connect Water Supply Hose
Owner's Manual for Power Washer
Connect High-Pressure Hose
and Lance
1. See
gun and hand-tighten.
2. Place spray gun and nozzle extension into
spray gun holder.
3. See
hose to pump. Hand tighten for threaded
connection.
Figure 2-13. Connect High-Pressure Hose
001540
Figure 2-14. Connect High-Pressure Hose
4. See
high-pressure hose to base of spray gun.
Hand-tighten for threaded connection.
001541
Figure 2-15. Connect High-Pressure Hose
to Spray Gun - Quick Connect
General Information and Setup
Figure 2-12. Connect lance to spray
Figure 2-12. Connect Lance
Figure 2-13. Connect high-pressure
to Triplex Pump
to Axial Pump (Hand Tight)
Figure 2-15 and Figure
000120
001542
000121
2-16. Connect
000269
5