Connect Hose And Water Supply To Pump - Generac 1536-1 El Manual Del Propietario

• Use fresh, clean unleaded automotive gasoline and store in
approved, clean, covered containers. Use clean fill
funnels. Never use "stale" gasoline left over from last
season or gasoline stored for long periods.
• Clean area around fuel fill cap, remove cap.
• Slowly add "UNLEADED" regular gasoline to fuel tank.
Use a funnel to prevent spillage. Slowly fill tank to about
1/2" below the bottom of the filler neck (Figure 7).
Figure 7 — Add Gasoline to Fuel Tank
1/2" Air
Space
• Install fuel cap and wipe up any spilled gasoline.
Connect Hose and Water Supply to
Pump
IMPORTANT: You must attach all hoses before you start
the engine. Starting engine without all hoses connected and
water supplied will damage the pump.
NOTE: Your pressure washer comes with a quick connect
that you can use to attach the high pressure hose to either
the pump or spray gun.
• Uncoil the high pressure hose and attach the female quick
connect to one end of the hose. Attach the male quick
connect to the high pressure fitting on the pump (Figure 8).
Figure 8 — Attach Quick Connect
• Attach the other end of the high pressure hose to the
high pressure outlet on the pump (Figure 9). Pull down
on the collar of the quick connect, slide onto the pump
and let go of collar. Pull on hose to be sure of a tight
connection.
Generac Portable Products 2,100 PSI High Pressure Washer
Tank
Fuel
Figure 9 — Connect High Pressure Hose to Water Outlet
• Attach the hose to the base of the spray gun (Figure 10).
Tighten by hand.
Figure 10 — Connect High Pressure Hose to Spray Gun
• Before you connect your garden hose to the water inlet,
inspect the inlet screen (Figure 11). Clean the screen if it
contains debris, replace it if it is damaged. DO NOT RUN
THE PRESSURE WASHER IF THE SCREEN IS DAMAGED.
Figure 11 — Connect Garden Hose to Water Inlet
• Run water through the garden hose for 30 seconds to
clean out any debris. Turn off water.
IMPORTANT: Do Not siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
• Connect the garden hose to the water inlet. Tighten by
hand (Figure 11).
CAUTION!
There MUST be at least ten feet of
unrestricted garden hose between the pressure washer
inlet and any flow shut off device, such as a 'Y' shut-off
connector or other convenience-type water shut-off valve.
Damage to pressure washer resulting from disregarding this
caution will not be covered by the warranty.
7
Connect High
Pressure Hose
Here
Inspect inlet
screen. Do Not
use if damaged;
clean if dirty.