Add Engine Oil; Connect Hose And Water Supply To Pump - Generac 1539 0 El Manual Del Propietario

• Secure handle to the pressure washer using the four
provided flange nuts.
• Slowly tip the pressure washer back in place and insert
the multi–colored nozzles in the spaces provided in the
handle.
Install Oil Dipstick on Pump
CAUTION!
You MUST remove the pump's shipping cap
and install the oil dipstick. Failure to do so will void the
warranty and damage the pump.
To install the oil dipstick:
• Make sure your unit is on a level surface.
• Remove and discard the shipping cap located on the
pump (Figure 2).
Figure 2 — Install Oil Dipstick onto the Pump
Remove shipping cap and
install oil dipstick here.
Pump Oil
Dipstick
• Install the oil dipstick.

Add Engine Oil

IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to the engine owners manual to add recommended
oil to engine.
Generac Portable Products 3000 PSI Pressure Washer
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
Add Gasoline
• Use clean regular unleaded fuel and store in approved
• Clean the area around the fuel fill cap, remove the cap.
Shipping Cap
• Install the fuel cap and wipe up any spilled gasoline.
Connect Hose and Water Supply to
IMPORTANT: You must attach all hoses before you start
the engine. Starting engine without all hoses connected and
water supplied will damage the pump.
• Uncoil high pressure hose and attach quick connect end
6
WARNING!
Never fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
WARNING!
Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away any
fuel spillage from engine and equipment before
starting.
clean covered containers. Use clean fill funnels. Never
use "stale" gasoline left over from last season or gasoline
stored for long periods.
Slowly fill tank to the bottom of the filler neck (Figure 3).
Figure 3 — Add Gasoline to Fuel Tank
Pump
of hose to the base of the spray gun (Figure 4). Pull
down on the collar of the quick connect, slide onto the
spray gun and let go of collar. Tug on hose to be sure of
a tight connection.
Maximum Fuel Level