HEINE mPack LL Manual De Instrucciones página 13

Setting up and operation
1 HEINE mPack LL
• Charge the mPack LL for two hours before using it for the first time.
Charge the mPack LL via the connector (11) with a separate HEINE
mains transformer or in the charging socket of the base unit (7).
• Connect the instrument to the connector (2) and select the required
brightness by means of the brightness control (3). The HEINE mPack LL
switches off with an audible click after use.
• With the mPack and base unit (7) it is possible to use a HEINE instrument
under static or mobile conditions if preferred. The mPack will be recharged
automatically when the attached HEINE instrument is switched off.
• The indicator (4) lights up as soon as the mPack LL is switched on at (3).
It must switch off when the mPack LL is switched off.
• General conditions for charging:
• Recharging time depends on the state of charge of the battery and lasts
for a maximum of 2 hours.
• When the battery is fully-charged the mPack LL charging logic switches off,
all LEDs are switched off.
• The battery cannot be overcharged.
2 HEINE mPack LL
• Attach the base unit to the wall by means of the wall bracket (6). Slide the
instrument support (1) or (8) onto the hinged support (5). Use (1) for the
headband or (8) for the S-Frame.
• Inserting the S-Frame into the instrument support:
• Insert the S-Frame under the holder (9).
• Make sure the S-Frame is correctly-positioned as in (10) so that it is
properly retained in position.
• The indicator (4) must light up as soon as the mPack LL is switched on at (3).
It must go out as soon as the mPack LL is switched off or the hinged support
is pressed down. When the instrument is removed the mPack LL switches on
the instrument automatically.
• The mPack LL can be recharged whether the power source is switched on or
not or whether an instrument is connected or not.
• The LED indicator works independently whether the mPack is used with the
base unit or not (see LED indicator).
3 Direct Use
If the battery of the mPack LL is completely discharged you can continue to
use the instrument with the mains transformer or in the EN 50.
Important note: During direct use with the mains transformer or in the EN50,
the battery will not be recharged simultaneously.
4 LED indicators (4) on the HEINE mPack LL
• During charging the LED's (4) operate sequentially, in use they remain
switched on.
• If the LEDs (4) remain switched off, the unit is non-operational or the mPack LL
is switched off (e.g. If the battery is completely discharged).
• The number of illuminated or sequentially-switched LEDs (4) indicates the
state of charge of the Li-ion battery. The state of charge is shown whether
an instrument is connected or not.
• All five LEDs illuminated indicate a fully-charged battery.
• If the yellow LED flashes on and off, the battery must be recharged. Switch
off the mPack LL and recharge it by means of the HEINE mains transformer
or the base unit (7).
Important note: The mPack LL switches off automatically (LED's switched off)
if the instrument used is defective.
®
for wall-mounting
®
®
®