Technoline WS6620 Manual De Instrucciones página 16

the unit's hang hole (RTS 1) on a screw (screw not included).
Alternatively, the unit can be place on a flat horizontal surface.
2. The unit can be placed indoor or outdoor. The unit is weather proof.
Do not submerge unit in water. Do not expose unit to water for
prolonged periods. Avoid accumulation of water and or snow on unit.
Avoid exposing unit to direct sunlight. Remove unit from the exterior in
extreme or harsh weather, including but not limited to hurricane,
typhoon, and cyclones seasons. Do not place the unit in area of high
winds.
3. Do not place the remote temperature sensor more than 30 meters (98
feet) from the receiving weather station. The remote temperature
sensor is most effective if there are no obstruction and interference
between the remote temperature sensor and the weather station. The
remote temperature sensor might have to closer than 30 meters if the
weather station is not able to receive any signals. This is due to
obstructions and interference. The user might need to experiment with
various locations to get the best reception.
Configuring Weather Station to receive remote temperature signals.
1. Follow the above instructions to set up remote temperature sensor.
2. Press and hold "IN/CH" button (9) on weather station for 3 seconds.
'CH' will flash. This will reset all temperature memories.
3. The weather station will begin scanning for signals for channel 1. As
soon as signals are received for channel 1, the temperature will be
displayed. The weather station will automatically scans for the other
channels. It will scan each channel for approximately 3 seconds
before skipping to the next channel.
4. Once all your channels are received press "IN/CH" button (9) once to
confirm the channel.
5. The weather station will receive a new signal automatically every 30
seconds to update the remote temperature.
6. Press "IN/CH" button (9) on weather station repeatedly to toggle
between channel 1 'CH1', channel 2 'CH2', and channel 3 'CH3'.
7. will be displayed if any of the remote temperature sensor's
battery needs replacing.
Temperature memory
1. Press "Max / Min" button (8) to display maximum recorded
temperature, minimum recorded temperature, and current
temperature. "MAX" indicates maximum temperature. "MIN" indicates
minimum temperature.
2. Press and hold "Max / Min" button (8) for approximately 3 seconds to
reset the maximum and minimum temperature and humidity records.
Temperature display
1. The "IN" temperature displays the indoor temperature. It is the
will no longer be displayed.